Configuring Communication To The Control System; Configuring The Communication Using Simatic S7 Control; Configuring The Communication With A Third-Party Control System; Installing The Gsd - Siemens SINAMICS G110M Function Manual
Fieldbuses
Hide thumbs
Also See for SINAMICS G110M:
- Operating instructions manual (428 pages) ,
- Original instructions manual (344 pages) ,
- Function manual (244 pages)
Table of Contents
Advertisement
3.5.4
Configuring communication to the control system
Configure the communication in the control system after you have connected the inverter to
the bus.
3.5.4.1
Configuring the communication using SIMATIC S7 control
● If the inverter is listed in the hardware library of HW-Conifg, you can configure the
communication in the SIMATIC control.
● If the inverter is not listed in the hardware library, you can either install the newest
STARTER or Startdrive version or install the GSD of the inverter via "Extras/GSD-Install
file" in HW-Config.
Example of configuring the communication with a SIMATIC control system
3.5.4.2
Configuring the communication with a third-party control system
If you are working with a third-party control system, you must install the device file (GSD) of
the inverter in the control before you configure the communication.
If you have installed the GSD, configure the communication. To do this, follow the
documentation of your control system.
3.5.4.3
Installing the GSD
Procedure
To load the GSD of the inverter in the control, proceed as follows:
1. Obtain the GSD
– either on the Internet:
– or from your inverter. To do this, insert a memory card into the inverter and set p0804
2. Unzip the GSDfile in a folder on your computer.
3. Import the GSDinto the configuration tool of your control.
You have now installed the GSD file.
Fieldbuses
Function Manual, 01/2016, FW V4.7 SP6, A5E34229197B AC
: Configuring PROFIBUS communication (Page 215)
Installing the GSD (Page 73) .
GSD (http://support.automation.siemens.com/WW/view/en/22339653/133100)
= 12. In this way, you will save the GSD on the memory card as (DPGSD.ZIP)
compressed file in the directory /SIEMENS/SINAMICS/DATA/CFG .
Communication via PROFIBUS and PROFINET
3.5 Communication via PROFIBUS
73
Advertisement
Table of Contents
