1.0 Know your aircraft
Tips:
The main structure of the ABS material, the new
The use of high
toughness coated
industrial and modular design, improve product
explosion-proof .It
development, easy installation and maintenance,
will be better to tear
1
replacement upgrades.
the film before use.
2
Equipped with FPV 5.8G map transmission
2
real-time transmission system, bring you not the
3
same visual effects.
1. Aircraft shell
4
7
2. Cover the screw hole
8
3. FPV system
7
4. EVA pad (fixed camera)
9
6
5. Rack
5
6
6. Rack cap screw hole
9
7. Forward rotation propeller
9
8. Reversing the propeller
10
9. Propeller guardrail
10. Body battery compartment
11
11. Battery
2.0 parameters
83.5 mm
Craft parameter
Main wing length: 66mm
Size: 83.5*83.5*42.2mm
Weight: 20g(without battery)
Motor: 6015 1S brush motor
Lipo battery: 3.7V 200mAh 35C
Flight time: 5min
Omnidirectional reception antenna
83.5 mm
Working temperature:-10℃ to +40℃
Frequency Table
Unit:MHz
CH1
CH2
CH3
CH4
CH5
CH6
CH7
CH8
Band 1
5865
5845
5825
5805
5785
5765
5745
5725
Band 2
5733
5752
5771
5790
5809
5828
5847
5866
Band 3
5705
5685
5665
5645
5885
5905
5925
5945
Band 4
5740
5760
5780
5800
5820
5840
5860
5880
Band 5
5658
5695
5732
5769
5806
5843
5880
5917
4.0. remote control
3 Different Speed Modes: High, Medium
And Low Speed Self-Tuning
"Di" pattern for H
4.1 Remote control function
"Di Di" pattern for M
introduction
"Di Di Di" pattern for L
Indicator light
Rolling keys
H/M/L Speed
Pre-fine key
Headless mode
Throttle putter
Directional putter
(up and down left and
(front and rear left
Metal joystick
right steering function)
and right side fly)
One key return button
Fine-tuning key
Left rotation fine tuning
4.2 Remote control
Right trim key
Right spin fine tuning
Switch
Left fine key
battery installed
Unscrew the screw and
Please use 3 "AAA 1.5V"
Close the battery cover
open the battery cover
batteries and assemble
and screw it on
them in positive and
FPV six-axis aircraft operating instructions
1.1 The architecture of the aircraft
3
2
1
Headless
Size of the
F P V
One key return
360 ° roll
mode
amount of control
5.8G 3dBi miniature antenna
5.8G 25mw map
transmission transmitter
6015 1s brush motor
8
1000TVL M7 Lens
120°FOV H170°
Wide angle camera
01
Key functions:
3.0 Frequency method
1、Short press the button to adjust the frequency
FPV system :5.8G 40CH
function, and at the frequency FR1-FR8 cycle
See Table 3 on the frequency table
between the switch.
2、Long press the button for 2 seconds (LD1
flashing when the release button) for the
adjustment frequency group function, and in the
Antenna
frequency group CH1-CH5 cycle between the
switch.
3、Long press the button for 5 seconds (LD1 from
CH1
CH2
CH3
CH4
CH5
flashing to off when the release press key) to
indicator
indicator
indicator
indicator
indicator
adjust the standard function, P system LD2
LD1
flashing, N system when LD2 long bright.
time indicator
Button
LD2
N / P indicator
Button
P system flashes
FR1
N system long bright
indicator
FR2
FR8
indicator
indicator
FR3
FR4
FR5
FR6
FR7
indicator
indicator
indicator
indicator
indicator
03
5.0.Aircraft Lipo battery
Plug the USB plug into the USB port of the computer (or the
charging
charger of the USB port with the DC5V output). At this time,
the USB charging port has a red indicator light and the
battery is connected to the USB charging cable. When the
red light is off, it indicates that it is charging. Charging time
30-40 minutes. To ensure safety, be sure to do so within
sight.
6.1.1.
The battery into the fuselage battery compartment, then the
6.0.Operational guidelines
battery port access to the fuselage power port, and placed on the
level, then the aircraft taillight flashing, open the remote control
6.1 Boot program
power switch, remote control issued a "tick" sound, then remote
control The remote control gives a "beep" once again, and then
the remote control indicator is turned on again. At this time, the
remote controller will be issued again. Bright, the aircraft LED light
is always bright, said the completion of the code.
6.1.2. After the
completion of the
aircraft on the
code, to promote
the left joystick
throttle can start
05
Red line
Black line
the aircraft.
(positive electrode)
(negative )
AGES 14+
6.2 Gyroscope proofreading
After the completion of the code, the aircraft
placed in the horizontal position,
Push the two joysticks at the same time to the
lower right corner 45 ° for gyro calibration. LED
lights flash quickly, proofreading is complete.
Tips: Before the aircraft take off, be sure to place the aircraft in the
horizontal plane proofreading, to ensure that the aircraft after the smooth
flight. When the aircraft by the impact or collision after the deviation, you can
also use this method to calibrate the gyroscope.
7.0. Operation and control
7.1 mode of operation
As sensitive, for beginners, it is recommended to slow operation of the rocker.
Such as the operation of the aircraft during the process of a slight decline, but
also slowly push the left rocker to climb to a certain height. Operation to avoid
a significant push of the throttle.
7.2 Operation mode
Aircraft movements fine-tuning
Slowly raise the throttle stick, when the aircraft to
leave the ground, if the aircraft tend to different
Six axis
directions, you can use fine-tuning correction action.
2.4GHz
Safe flight
gyroscope
1. Adjust the front and rear fine adjustment
When the aircraft leaves the ground, the aircraft is
moved forward / backward, forward, and the fine
adjustment is adjusted downward.
When you move backwards, fine tune upwards.
30mm propeller
2. Adjust the aircraft side fly fine tuning
When the aircraft leaves the ground, flying
to the left / right side of the side fly.
Fly to the right, fine-tune the left to adjust.
Fly to the left, fine-tune the right to adjust.
Lipo battery
3.7V 200mAh 35C
02
(The bottom of the aircraft)
Orientation
F
Headless mode
Antenna
As shown in the figure above, in the headless mode (the aircraft LED is in a flashing
state), regardless of where the aircraft is located in front of the location, now the
remote control is located in the rear of the aircraft, then pull down the direction of the
operating lever You can recall the aircraft, push up the direction of the rod so the
aircraft will fly farther away.
04
12.0. Propeller installation method
The propeller of the aircraft is installed with the
location requirements, please press the corresponding
code to install,coded as shown below.
Camera
A
B
B
A
13.0. roubleshooting
13.1 remote control and the aircraft did not
respond to the solution:
1) Make sure the code is successful. See page
4 for the code method.
2) whether the battery is low.
3) Make sure the remote control is the
original match.
13.2 Can not roll the solution:
1) Restart the rollover function key.
06
2) Check whether the lithium battery is too low,
re-charge.
When the left joystick (throttle) is pushed
up or down, the aircraft rises or falls
accordingly.
When the right operating lever
(direction) is pushed up or down, the
aircraft forwards or retracts accordingly.
07
8.0. 360 ° rollover
The aircraft can do 360 ° rollover by the following
joystick operation.
Forward
Up
Down
Backwards
Note: Keep the aircraft at a height of 2-3 meters when rolling, so that the aircraft is
easier to maintain the height after rolling.
9.0. Headless mode
9.1 Headless mode switching
Left
Start and set: After the completion of the aircraft frequency, the aircraft placed in the
Right
flat level, or hover in the air to ensure that the head of the aircraft and the remote
control in front of the same direction, press the headless mode button (aircraft LED
Fly on
Fly on
the left
the right
lights flash) Start headless mode.
9
Exit the headless mode: Press the headless mode button again (the aircraft LED is
lit), then exit the headless mode.
9.2 One key return
Press the button to return to the channel, you can correct the way through
Operating
Before and after
the right joystick to correct the channel (to the front of the frequency before
F
the start in order to return to normal), the aircraft will automatically return.
During the return process, press the function key combination on the remote
control or push the right joystick "forward" to return the aircraft.
L
R
Tips: low alarm
When the aircraft appears tapping flashing, indicating that the aircraft is
B
about to run out of power, then the aircraft
Will automatically turn off the trick, the aircraft in the conventional
control state, the maintenance time of 30 seconds.
10.0. Flying environment
Do not use this product in the following environments to
avoid accidental injury or damage to the aircraft.
11
1) high-voltage line lots, park lots, railway lots, highway lots and so on
2) thunderstorms weather, windy weather, rain and snow weather.
14.0. FPV Troubleshooting
Install the propeller: Hold the small hat of the
14.1 Goggle display screen No image:
propeller, press the motor shaft to press it, be
1) Check to see if the power supply of the
careful not to deform the propeller.
goggle and the power supply of the aircraft
is normal, battery power is sufficient.
2) Check whether the goggle receive channel
A
and transmitter channel is consistent.
3) Check the transmitter and the end of the
goggle N / P standard is consistent.
15.0. Accessories list
13.3 aircraft fuselage solution:
1) Check if the propeller is deformed and replace
the new propeller.
2) turn off the aircraft power to restart.
3) Place the aircraft in the horizontal plane to
recalibrate the gyroscope.
Aircraft x1
13.4 Aircraft can not take off the solution:
1) Check that the screw is installed correctly.
2) whether the aircraft crash cover is loose, hinder
the propeller rotation.
3) whether the aircraft has electricity,
13
LiPo battery x1
low power, the lights flashing.
Rise
上升
Turn right
Turn left
Decline
When the left joystick (throttle) is pushed
left or right, the aircraft turns left or right
accordingly.
Forward
Fly on
Fly on
the left
the right
Backwards
When the right-hand lever (direction) is
pushed to the left or to the right, the
corresponding side fly or fly on the right
side of the aircraft.
08
8.1 Left 360 ° roll
8.3 Forward 360 °roll
Short press the scroll
Short press the scroll
key, and then push the
key, and then push the
right lever to the left, the
right lever up, the
corresponding aircraft to
corresponding forward
the left flip 360 °
side of the aircraft
8.4 Back 360 °roll
8.2 Right 360 ° roll
Short press the right scroll
Short press the scroll key,
key, and then push the
and then push the right
right lever down, the
lever to the right, the
corresponding rear side of
corresponding aircraft to
the aircraft turned 360 °
the right flip 360 °
10
One key return
11.0. End flight
① manual landing.
② first turn off the power of the aircraft, and
then turn off the remote control power.
③ Remove the aircraft from the aircraft.
12
14.2 Goggle received the image signal quality is poor or
wireless transmission distance near:
1) whether the same frequency of radio transmission
equipment interference, FPV system should choose other
frequencies, to avoid the interference frequency or to
avoid the use of the same site.
2) Whether the goggle antenna is installed.
3) whether the goggle and the aircraft between the
mountains, houses, trees and other obstacles, please
use the FPV system in the open space.
A
B
Propeller Ax3
Remote control x1
Propeller Bx3
USB charging cable x1
INSTRUCTION MANUAL
14
Screwdriver x1
Manual x1