hit counter script

Ipv6 Traffic-Filter - Cisco Nexus 5500 Series Command Reference Manual

Nx-os security command reference
Hide thumbs Also See for Nexus 5500 Series:
Table of Contents

Advertisement

Chapter
I Commands

ipv6 traffic-filter

To apply an IPv6 access control list (ACL) to an interface, use the ipv6 traffic-filter command. To
remove an IPv6 ACL from an interface, use the no form of this command.
Syntax Description
access-list-name
in
Command Default
None
Command Modes
Interface configuration mode
Virtual Ethernet interface configuration mode
Command History
Release
5.2(1)N1(1)
Usage Guidelines
By default, no IPv6 ACLs are applied to an interface.
You can use the ipv6 traffic-filter command to apply an IPv6 ACL to the following interface types:
You must enable VLAN interfaces globally before you can configure a VLAN interface. For more
Note
information, see the feature interface-vlan command.
The switch applies ACLs to inbound traffic only. The switch checks inbound packets against the rules in
the ACL. If the first matching rule permits the packet, the switch continues to process the packet. If the
first matching rule denies the packet, the switch drops the packet and returns an ICMP host-unreachable
message.
If you delete the specified ACL from the device without removing the ACL from an interface, the deleted
ACL does not affect traffic on the interface.
OL-27883-02
ipv6 traffic-filter access-list-name in
no ipv6 traffic-filter access-list-name in
Name of the IPv6 ACL, which can be up to 64 alphanumeric, case-sensitive
characters.
Specifies that the device applies the ACL to inbound traffic.
Modification
This command was introduced.
Ethernet interfaces
EtherChannel interfaces
Virtual Ethernet interface
VLAN interfaces
Cisco Nexus 5500 Series NX-OS Security Command Reference
ipv6 traffic-filter
143

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents

Save PDF