Toshiba QOSMIO G10 Maintenance Manual page 91
Hide thumbs
Also See for QOSMIO G10:
- User manual (235 pages) ,
- User reference manual (31 pages) ,
- User manual (276 pages)
Table of Contents
Advertisement
2.5 USB FDD Troubleshooting
Procedure 2
Diagnostic Test Program Execution Check
Insert the Diagnostics Disk in the USB FDD, turn on the computer and run the test. Refer to
Chapter 3, Tests and Diagnostics, for more information about the diagnostics test procedures.
Make sure the floppy disk is formatted correctly and that the write protect tab is disabled.
Floppy disk drive test error codes and their status names are listed in Table 2-7. If any other
errors occur while executing the FDD diagnostics test, go to Check 1.
Code
Check 1
If the following message is displayed, disable the write protect tab on the floppy
disk by sliding the write protect tab to "write enable". If any other message
appears, perform Check 2.
Write protected
Check 2
Make sure the floppy disk is formatted correctly. If it is, go to Procedure 3.
2-38
Table 2-7 FDD error code and status
Status
01h
Bad command
02h
Address mark not found
03h
Write protected
04h
Record not found
06h
Media replaced
08h
DMA overrun error
09h
DMA boundary error
10h
CRC error
20h
FDC error
40h
Seek error
60h
FDD not drive
80h
Time out error (Not ready)
EEh
Write buffer error
FFh
Data compare error
2 Troubleshooting Procedures
QOSMIO G10 Maintenance Manual (960-497)
Advertisement
Chapters
Table of Contents
Troubleshooting
