Summary of Contents for Eagle 1225
- Page 1 INC. MODEL 1225 TWO WAY AUDIO SYSTEM WITH REMOTE DIAL-UP AND AUTO-DETECT INSTALLATION INSTRUCTIONS...
- Page 2 1. A communicator/control panel to provide Connections to power 12VDC & Ground) and telephone (Tip & Ring). 3. A minimum of one speaker/microphone (Eagle Model 2170). Up to two Model 2170’s may be used. 2.3 CENTRAL STATION. kiss 1. A receiver with listen-in or two way capability (stays on line after off).
-
Page 3: Installation Summary
When SW2 is in the OFF position a trigger input will activate a five (5) minute window. The 1225 will answer the phone line as soon as it sees one ring within this window. The system will ignore any invalid phone calls (see section 4.2). - Page 4 SW4 - ON = Only last minute warning tone will sound. OFF = All progress tones will sound. This enables the installer to disable all the progress tones (one per minute) except the last minute shut down warning tone. This is beneficial for use in demo kits. SW5 - ON = Enables the CENTRAL STATION DETECTION feature.
- Page 5 Trigger input. Use when control panel has dedicated two way activation trip. YELLOW: Connect alarm output here (negative voltage active). This activates the Model 1225’s internal siren driver. Note: do not use with GREEN (positive) input. Connect alarm output here (positive voltage active). This activates the Model 1225’s internal siren GREEN: driver.
- Page 6 RELAY TELCO JACK SIREN DRIVER FROM PANEL (+) (SEE MANUAL) PURPLE SIREN DRIVER FROM PANEL (-) (SEE MANUAL) BLUE ALARM OUTPUT FROM PANEL (+) (SEE MANUAL) ALARM OUTPUT FROM PANEL (-) (SEE MANUAL) T R I G G E R INPUT (+/-) (SEE MANUAL) +I2 VDC FROM PANEL GND (-) FROM PANEL DIALER...
- Page 7 FIVE MINUTE WINDOW. The Model 1225 has a call back mode which activates upon a trip. The trip can be initiated on the trip input (orange wire) or from the auto detect circuit. The sets up the system to answer an alarm which has just been reported by the digital communicator (SW2 is OFF), the operator will have 5 minutes in which to call back the system and have it answer within one ring.
-
Page 8: Controlling The Module
CAUTION: If there is a loud, continuous background noise, such a radio, the central station operator should not attempt to increase the gain of the Model 1225, as this may cause the system to loose the ability to recognize the tones from the central station. -
Page 9: Fcc Requirements
6.2 EXTERNAL SIREN DRIVER. It may be desired to connect an external siren driver to the Eagle Model 1225 utilizing the speaker within the Model 2170 SPEAKER/MIC. The module must be configured to accept this input. Jumpers P5 and P6 (both) must be moved to positions 2 and 3. - Page 10 O.OB Eagle Security Products, Inc. warrants that the products of its manufacture shall be free from defects in materials or workmanship to one Year from the date of invoice if such goods have been properly installed, are subject to normal proper use, and have not been modified in any manner whatsoever.