•
Note that a new battery's full performance is achieved only after two or three
complete charge and discharge cycles. Battery operation time may be less
than the estimated times during the first charges. This condition is normal.
•
You can use your phone while the battery is charging. However, if the battery
is completely empty, it may need to recharge a few minutes before you can
make or receive calls or the battery indicator appears.
•
After the first charge, you can make and receive calls during the charging
cycle, but the calls interrupt the charge. When the phone call ends, the charge
will resume.
•
The bars on the screen stop scrolling and remain constant when the phone is
fully charged. If you switch the phone on when charging is complete, the
message Battery full momentarily appears in the display.
Charging time depends on the charger and the battery used. For example, charging
a BLC-2 battery with the ACP-12 charger takes about two hours in standby mode.
Important: When the phone's battery is fully charged, be sure to
disconnect the phone from the charger.
REMOVE THE BACK COVER
With the back of the phone facing you,
push the back cover release button.
Note: Before removing the cover,
always switch off the power and
disconnect the charger and any
other device. Avoid touching
electronic components while the
cover is removed. Always store
and use the device with the cover attached.
REMOVE THE BATTERY
After you have removed the back cover, insert
your finger into the finger grip and lift the
battery from its compartment.
12
Copyright © Nokia 2003