I.link (Ieee1394); Modem - Toshiba TECRA M3 User Manual
Portable personal computer
Hide thumbs
Also See for TECRA M3:
- Maintenance manual (435 pages) ,
- User manual (306 pages) ,
- Specification sheet (8 pages)
Table of Contents
Advertisement
Troubleshooting
i.LINK (IEEE1394)
Problem
i.LINK device does not
function
Modem
Refer to Appendix C,
Problem
Communication
software can't initialize
modem
You can hear a dial
tone but can't make a
call
You place a call, but a
connection can't be
made
After making a call you
can't hear a ring
Communication is cut
off unexpectedly
A CONNECT display is
quickly replaced by NO
CARRIER
9-20
Procedure
Make sure the cable is securely connected to the
computer and to the device.
Make sure the device's power is turned on.
Reinstall the drivers. Open the Windows
Control Panel and double-click the Add
Hardware icon. Follow the on-screen
directions.
Restart Windows.
If problems persist, contact your dealer.
AT Commands
and Appendix D, S-registers.
Procedure
Make sure the computer's internal modem
settings are correct. Refer to Phone and Modem
Properties in the Control Panel.
If the call is going through a PBX machine, make
sure the communication application's tone dial
detection feature is disabled.
You can also use the ATX command. Refer to
Appendix C,
AT
Make sure the settings are correct in your
communications application.
Make sure the tone or pulse selection in your
communications application is set correctly.
You can also use the ATD command. Refer to
Appendix C,
AT
The computer will automatically cut off
communication when connection with the carrier
is not successful for a set time interval. Try
lengthening this time interval.
Check the error control setting in your
communications application.
You can also use the AT\N command. Refer to
Appendix C,
AT
Commands.
Commands.
Commands.
User's Manual
Advertisement
Table of Contents
