Table of Contents
Advertisement
Ribbon End Point
|
|
This parameter adjusts the point at which the system will declare the ribbon
|
as being expended. The life count will always be from 100% to 0%, but if a
|
darker setting is selected 0% will be reached more quickly. If a lighter setting
is selected, the system will extend the time it takes to reach 0%. The range of
|
values are as follows:
|
v Lighter -4 (the default)
|
v Darker +1 through Darker +6
|
v Normal
|
v Lighter -1 through Lighter -10
|
Note: This value can be adjusted at any time and the display will
|
|
|
Save Current Values
|
|
This option allows you to save your custom sets to meet different print job
|
requirements. This eliminates the need to change the parameter settings for
|
each new job.
The custom sets are stored in NVRAM-they will not be lost if you power off
|
the printer.
|
Factory default is a factory-preset custom set; it cannot be changed or saved.
|
IMPORTANT: A new custom set will overwrite an existing custom set if the
|
|
|
|
|
Change Power On Set
|
|
You can specify which of the custom sets will be the power-on custom set.
|
The printer will power on with the factory set values or with one of the
|
customized configurations.
Print a Test Page
As a test, print a configuration by following the instructions below:
Step
1. Make sure the printer is on. Raise the printer cover.
automatically adjust to show the correct percentage relative to the new
end point.
PROTECT CUSTOM SETS parameter is disabled (for
example, a new Custom Set 4 will overwrite an existing
Custom Set 4). See the "Protect Custom Sets" in the IBM
Infoprint 6500 Line Matrix Printers User's Manual.
Key
Result
Quick Setup Menu
Notes
Basic Operating Procedures
55
- Quick Links:
- Load the Paper (Standard Configuration)
Hide quick links:
Advertisement
Table of Contents
