SAFETy INSTruCTIONS
Please read these safety precautions carefully before using the product.
WArNING
y Do not place the TV and
remote control in the following
environments:
- A location exposed to
direct sunlight
- An area with high humidity
such as a bathroom
- Near any heat source
such as stoves and other
devices that produce heat
- Near kitchen counters or
humidifiers where they can
easily be exposed to steam
or oil
- An area exposed to rain or
wind
- Near containers of water
such as vases
Otherwise, this may result in
fire, electric shock, malfunction
or product deformation.
y Do not place the product
where it might be exposed to
dust.
This may cause a fire hazard.
y Mains plug is the
disconnecting device. The
plug must remain readily
operable.
y Do not touch the power plug
with wet hands. Additionally, if
the cord pin is wet or covered
with dust, dry the power plug
completely or wipe dust off.
You may be electrocuted due
to excess moisture.
y Make sure to connect the
power cable to the grounded
current. (Except for devices
which are not grounded.)
You may be electrocuted or
injured.
SAFETY INSTRUCTIONS
y Insert the power cable
completely into wall socket.
If the power cable is not
inserted completely into wall
socket, a fire could break out.
y Ensure the power cord does
not come into contact with
hot objects such as a heater.
This may cause a fire or an
electric shock hazard.
y Do not place a heavy object,
or the product itself, on power
cables.
Otherwise, this may result in
fire or electric shock.
y Bend antenna cable between
inside and outside building to
prevent rain from flowing in.
This may cause water
damaged inside the Product
and could give an electric
shock.
y When mounting a TV on the
wall, make sure not to install
TV by hanging power and
signal cables on the back of
the TV.
It may cause fire, electric
shock.
y Do not plug too many
electrical devices into a single
multiple electrical outlet.
Otherwise, this may result in
fire due to over-heating.
y Do not drop the product or let
it fall over when connecting
external devices.
Otherwise, this may result
in injury or damage to the
product.
3