Symptom-To-Fru Index; Numeric Error Codes - IBM ThinkPad X40 Hardware Maintenance Manual
Mobile systems
Hide thumbs
Also See for ThinkPad X40:
- Service and troubleshooting manual (116 pages) ,
- User manual (18 pages) ,
- Setup poster (2 pages)
Table of Contents
Advertisement
Symptom-to-FRU index
The symptom-to-FRU index in this section lists symptoms
and errors and their possible causes. The most likely
cause is listed first, in boldface type.
Note: Do the FRU replacement or other actions in the
sequence shown in the column headed "FRU or
action, in sequence." If replacing a FRU does not
solve the problem, put the original part back in the
computer. Do not replace a nondefective FRU.
This index can also help you determine, during regular
servicing, what FRUs are likely to need to be replaced
next.
A numeric error is displayed for each error detected in
POST or system operation. In the displays, n can be any
number.
If no numeric code is displayed, check the narrative
descriptions of symptoms. If the symptom is not described
there, go to "Intermittent problems" on page 68.
Note
For an IBM device not supported by diagnostic
codes in the ThinkPad notebook computers, see the
manual for that device.
Numeric error codes
Symptom or error
0175
Bad CRC1, stop POST
task—EEPROM CRC1 is not
correct (block #6)
0176
System Security—The system
has been tampered with.
0177
Bad SVP data, stop POST
task—Checksum of the
supervisor password in the
EEPROM is not correct.
(continued)
Symptom-to-FRU index
FRU or action, in sequence
System board
Replace planar.(System halt)
1. Run IBM BIOS Setup
Utility, and then save
current setting by
pressing F10.
2. System board.
System board
ThinkPad X40
57
Advertisement
Table of Contents
