Configuring The Lucid Ada 88192 Converter - HP xw8400 Workstation Hardware Setup Manual
Hide thumbs
Also See for xw8400 Workstation:
- User manual (216 pages) ,
- Service and technical reference manual (210 pages) ,
- Technical reference manual (200 pages)
Table of Contents
Advertisement
4
Setting Up Audio Hardware
Configuring the Lucid ADA 88192 Converter
You must manually configure the Lucid converter for either remote or local control. This section
describes how to use the controls on the front of the converter to adjust settings, and lists the
proper settings for remote control and for local control.
Adjusting Lucid ADA 88192 Converter Settings
You configure the converter through a series of setup menus that appear in the display on the
front of the converter. Use the encoder dial and button immediately to the right of the display to
navigate these menus and adjust settings.
The top level setup menu contains the following menu items: ADAT, AES, Analog, Meter, Route,
Sync, and System. Each of these menu items takes you into a submenu, from which you can
select and adjust settings.
The procedures below provide basic information on navigating and adjusting settings. If you
require additional information, refer to the Lucid ADA 88192 manual included with your
shipment.
To navigate menus and adjust settings:
Use the encoder dial and the button as follows:
To:
Select a menu option Rotate the dial to highlight the option, then press the dial to select
Back up one level in
the menu tree
Navigate to the top
level setup menu
To reset all settings to their factory defaults:
1.
In the top level setup menu, select System, then select Miscellany.
In the Miscellany menu, select Defaults: RESET.
2.
All settings are reset to their factory defaults.
N
:
The factory default for the items in the AES setup menu is SRC ON. Both local and remote
OTE
control require these items to be set to SRC OFF. If you reset to defaults, be sure to manually set
these items back to OFF (you cannot adjust these settings remotely).
38
Do this:
that option. If the option you select has choices (as for example in
the Route menu), rotate the dial again to move through the choices,
and press the dial to select an option.
Press the button.
Press the button. Repeat until you are in the top level setup menu.
Advertisement
Table of Contents
