Table of Contents
Advertisement
(Continued)
Remote Control
This page is for when operating your TV using
the remote control of this product.
Operating the TV Using the
Remote Control
Setting the manufacturer's code
1
Slide the remote control mode
selector to the TV side.
2
Hold down
NOTE
• Hold down
until step 4 is completed.
3
Press
and release.
13
.
4
Press number buttons (1-9, 0).
Examples:
For a Hitachi TV: Press 1, then 0.
For a Toshiba TV: Press 0, then 8.
If there are two or more manufacturer's codes, try
them in turn and select the one that causes the
product to work properly.
Manufacturer
Code
JVC
01
Hitachi
10
Magnavox
02
Mitsubishi
03
Panasonic
04, 11
Philips
14
RCA
05
5
Release
.
NOTE
• The manufacturer's codes may be changed without
notice. You may not be able to operate a TV
produced by the manufacturer shown above.
For TV operation
Operate the remote control by pointing it towards
the TV.
Turn on/off the power.
Change channels.
Adjust volume.
-
/
/
Change between the previously
selected channel and the cur-
rent channel.
Change between TV and video
input.
*1 Make sure to slide the remote control mode selector
to the TV side in advance.
NOTE
• When the batteries are replaced, perform the man-
ufacturer's code setting again.
Introduction
Manufacturer
Code
Samsung
12
Sanyo
13
Sharp
06
Sony
07
Toshiba
08
Zenith
09
Select channels.
*1
- Quick Links:
- Connecting the Sub-Woofer Equipment
Hide quick links:
Advertisement
Table of Contents
