Table of Contents
Advertisement
Care And Maintenance
Handle your CDs and tapes carefully, and they will last a long
time.
• Only CDs bearing these marks can be
used with this System. However, contin-
ued use of irregular shape CDs (heart-
shape, octagonal, etc.) can damage the
System.
Recordable
ReWritable
• Remove the CD from its case by holding
it at the edges while pressing the case's
center hole lightly.
• Do not touch the shiny surface of the
CD, or bend the CD.
• Put the CD back in its case after use to
prevent warping.
• Be careful not to scratch the surface of
the CD when placing it back in the case.
• Avoid exposure to direct sunlight, tem-
perature extremes, and moisture.
• A dirty CD may not play correctly. If a
CD does become dirty, wipe it with a
soft cloth in a straight line from center to
edge.
CAUTION:
• Do not use any solvent (for example, conven-
tional record cleaner, spray thinner, benzine,
etc.) to clean a CD.
In general, you will have the best performance by keeping your
CDs and the mechanism clean.
• Store CDs in their cases, and keep them in cabinets or on
shelves.
• Keep the System's Top Cover closed when not in use.
Moisture may condense on the lens inside
the System in the following cases:
• After turning on heating in the room.
• In a damp room.
• If the System is brought directly from a
cold to a warm place.
Should this occur, the System may mal-
function. In this case, leave the System
turned on for a few hours until the moisture
evaporates, unplug the AC power cord, and
then plug it in again.
25
• If the tape is loose in its cassette, take up
the slack by inserting a pencil in one of
the reels and rotating.
• If the tape is loose, it may get stretched,
cut, or caught in the cassette.
• Do not touch the tape surface.
• Do not store the tape:
- In dusty places
- In direct sunlight or heat
- In moist areas
- On a TV or speaker
- Near a magnet
• If the heads, capstans, and pinch-rollers of the Cassette Deck
become dirty, the following will occur:
- Loss of sound quality
- Discontinuous sound
- Fading
- Incomplete erasure
- Difficulty recording
• Clean the heads, capstans, and pinch-rollers using a cotton
swab moistened with alcohol.
Capstan
Heads
• If the heads become magnetized, the Unit will produce noise or
lose high frequencies.
• To demagnetize the heads, turn off the Unit, and use a head
demagnetizer (available at electronics and record shops).
Pinch-roller
- Quick Links:
- Demo Mode
- To Load Cds
- Troubleshooting
- Specifications
Hide quick links:
Advertisement
Chapters
Table of Contents
Troubleshooting
