LINE WITH MARK ! ON THE SCHEMATIC DIAGRAMS AND IN THE PARTS LIST ARE CRITICAL TO SAFE OPERATION. REPLACE THESE COMPONENTS WITH SONY PARTS WHOSE PART NUMBERS APPEAR AS SHOWN IN THIS MANUAL OR IN SUPPLEMENTS PUB- LISHED BY SONY.
SECTION 2 DISASSEMBLY Note: Follow the disassembly procedure in the numerical order given. CASE 1 screw (case3 TP2) 1 two screws (case3 TP2) 2 case 1 two screws (case3 TP2) FRONT PANEL SECTION 3 screw (BVTP3 × 8) 2 three connectors (CNP702 –...
SECTION 3 TEST MODE REAR PAENL SECTION Initialization Mode All preset contents are cleared when this mode is activated. When returning the unit to the customer after completing repairs, per- form this operation to clear the unit. 4 rear panel section Procedure: 3 two screws [TUNER]...
Page 7
STR-DE235 4-2. BLOCK DIAGRAM – MAIN Section (2/2) – J741 PHONES S701–2 S701–3 POWER AMP S701–2–1 IC701 (1/2) SPEAKERS A SPEAKERS A Ø ON ø OFF Ø ON ø OFF TM701 +VOUT1 FINAL –1 DRIVER DRIVER –VOUT1 DRIVE (Page 8)
Page 9
4-4. NOTES FOR PRINTED WIRING BOARDS AND SCHEMATIC DIAGRAMS • Circuit Boards Location Note on Printed Wiring Board: Note on Schematic Diagram: • X : parts extracted from the component side. • All capacitors are in µF unless otherwise noted. pF: µµF •...
4-15. IC PIN FUNCTION DESCRIPTION • DISPLAY BOARD IC201 µPD78045FGF-082-3B9 (SYSTEM CONTROLLER, FL DRIVER) Pin No. Pin Name Description 1 to 7 DIG7 to DIG1 Digit drive signal output to the fluorescent indicator tube (FL201) — Power supply terminal (+5V) Serial data transfer clock signal output to the dolby surround pro-logic circuit (IC300, 301), S.CLK LC78212 (IC401) and PLL IC on FM/AM tuner pack “L”...
Page 23
Pin No. Pin Name Description Motor drive signal (volume up direction) output to the volume motor drive (IC202) VOL UP “H” active SYS-POWER Power on/off switch (S200 I/u) input terminal “L” is input when key pressing TUNER-MUTE Muting control signal output to the FM/AM tuner pack “H”: muting on RDS CLK IN RDS serial clock signal input from the RDS decoder (IC1) Power down detection signal input from the reset signal generator (IC950)
SECTION 5 EXPLODED VIEWS NOTE: • Items marked “*” are not stocked since they • -XX and -X mean standardized parts, so they The components identified by mark ! or dotted line with mark may have some difference from the original are seldom required for routine service.
Page 26
(3) CHASSIS SECTION T901 supplied supplied The components identified by mark ! or dotted line with mark ! are critical for safety. Replace only with part number specified. Ref. No. Part No. Description Remark Ref. No. Part No. Description Remark 4-217-872-11 BOTTOM COVER 4-216-800-01 BACK PANEL (E25) (AEP) 4-216-798-11 SUB (MOLD)
SECTION 6 DISPLAY ELECTRICAL PARTS LIST NOTE: • Due to standardization, replacements in the • Items marked “*” are not stocked since they The components identified by mark ! or dotted line with mark parts list may be different from the parts speci- are seldom required for routine service.