Installing The Bezels; Working With Environmental Service Modules; Installing An Additional Esm - IBM DS3500 Installation, User's, And Maintenance Manual
Ibm system storage ds3500 and exp3500 storage subsystem
Hide thumbs
Also See for DS3500:
- Introduction and implementation manual (790 pages) ,
- Installation, user's, and maintenance manual (193 pages) ,
- Installation, user & maintenance manual (180 pages)
Table of Contents
Advertisement
1. If the storage subsystem is on a table or other flat surface, elevate the storage
2. Grasp the handle on the front of the bezel and pull until the bezel is clear of
3. Lift the bezel off the chassis flange.
Installing the bezels
To install either the left or right bezel, complete the following steps:
1. Fit the cutout that is on the top of the bezel over the tab on the chassis flange.
2. Rotate the bezel down until it snaps into place. Ensure that the inside surface
Working with environmental service modules
This section describes how to add or replace an ESM.
Attention: To avoid overheating the storage enclosure and causing damage to its
components, replace failed parts within 10 minutes. The Recovery Guru in the
Storage Manager software identifies failed parts.
Do not remove the failed part from the storage enclosure until you:
v Review the replacement procedure for the failed part in this guide.
v Locate screw drivers or any other hand tools that you might need to replace the
v Receive the replacement part and are ready to install it in the enclosure.
Before you begin, ensure that you wear an anti-static wrist strap.
Installing an additional ESM
The storage enclosure comes with one environmental services module (ESM). If
your controller supports redundant drive paths (see the documentation that comes
with the controller or the device that contains the controller), you can install a
second ESM.
To install a second ESM, complete the following steps:
1. Read the safety information that begins on page "Safety" on page ix and "Best
2. Remove the ESM filler panel from the rightmost ESM bay:
DANGER
3. Place the ESM on a dry, static-free level surface.
4. Ensure that the release levers on the ESM are in the open position.
5. Slide the ESM into the bay until it stops.
subsystem front slightly or extend the front over the table edge.
the bottom tab on the chassis flange.
of the bezel is flush with the chassis.
failed part.
practices guidelines" on page 8.
a. Open the two release levers. The ESM filler panel moves out of the bay
approximately 0.6 cm (0.25 inch).
b. Slide the ESM filler panel out of the bay and set it aside.
Electrical voltage and current from power cables are hazardous. To avoid a
shock hazard, always place electrical equipment on dry, static-free level
surfaces. Never turn on any electrical equipment when there is evidence of
fire, water, or structural damage.
Chapter 5. Replacing components
157
Advertisement
Table of Contents
Troubleshooting
