Page 6
Antes de instalar este produto, leia as Informações sobre Segurança. Pred inštaláciou tohto zariadenia si pečítaje Bezpečnostné predpisy. Antes de instalar este producto lea la información de seguridad. Läs säkerhetsinformationen innan du installerar den här produkten. IBM Internal Zip Drive: User’s Guide...
Your feedback is valuable to us in developing products and services that are important to you, as well as in developing better ways to communicate with you. Register your option on the IBM Web site at http://www.ibm.com/pc/register...
Product description The IBM Internal Zip Drive is a 3.5-inch AT Attachment Packet Interface (ATAPI) drive that works only with Zip disks and is supported only in computers that use the AT attachment/integrated drive electronics (ATA/IDE) architecture.
6. If you must put the drive down, place the antistatic bag on a flat, padded surface, such as a magazine, and place the drive on the bag with the component side facing up. IBM Internal Zip Drive: User’s Guide...
Page 11
7. Do not insert a Zip disk when the drive power is turned off. Installation and user’s guide...
Page 12
3. Using a straightened paper clip, as shown in the illustration, press on the right tab of the faceplate to detach it from the drive; then slowly and gently remove the faceplate. Do not bend the hooks that secure the top of the faceplate. IBM Internal Zip Drive: User’s Guide...
Page 13
4. Align the drive-light pipe on the drive with the light-pipe hole 1 on the new faceplate; then secure the right side of the new faceplate to the hook 2 on the corner of the drive. 5. Attach the left side of the new faceplate to the drive. 6.
Page 14
Zip drive, an IDE hard disk drive, or a CD-ROM drive) to the IDE cable. Cable select Note: The cable-select configuration does not apply to IBM computers. If you are using an IBM computer, disregard the cable-select information in this section.
Page 15
If you are installing the drive in a 5.25-inch bay, go to “Step 5. Preparing the drive for a 5.25-inch bay”. Step 5. Preparing the drive for a 5.25-inch bay You must use the 5.25-inch conversion tray to install the drive in a half-high industry-standard 5.25-inch bay.
Page 16
IDE devices. Be sure that the startup hard disk drive is configured as a master on the IDE cable that is connected to the primary IDE port. Refer to the documentation that comes with your computer for information on the primary IDE port. IBM Internal Zip Drive: User’s Guide...
Page 17
Connect an available dc power-cable connector to the four-pin dc power connector on the Zip drive, as shown. Pin 1 Pin 40 If all power connectors are in use, you will need to purchase a dc Y-connector (available at many electronic stores) to provide power for two devices from one power cable.
Page 18
Obtaining and using the optional IomegaWare software After successfully completing installation, you are now able to read and write the appropriate Zip media to your IBM Internal Zip Drive. In addition, optional Iomega software, called IomegaWare, is available with the following features: v Copy Disk tool: enables you to copy files greater than 32 MB.
Page 19
Store multimedia files that require large amounts of storage space Formatting Zip disks Note: IBM Internal Zip 100 Drives format Zip 100 media only. IBM Internal Zip 250 Drives can format Zip 100 and Zip 250 media. To format a Zip disk, do the following: 1.
Page 20
To read-protect or write-protect a Zip disk (after IomegaWare software is installed): 1. On your desktop, double-click My Computer. 2. Read- or write-protect the Zip disk by right-clicking the Zip drive icon and clicking the Protect option. 1-12 IBM Internal Zip Drive: User’s Guide...
Page 21
Note: If a Zip disk is not inserted in the drive, the Protect option will not be available. Repeat these steps to remove read-protection or write-protection. Reducing power consumption when using Zip disks The Zip drive has an automatic sleep mode. This capability reduces power consumption and prolongs the life of Zip disks.
Page 22
1-14 IBM Internal Zip Drive: User’s Guide...
During the warranty period, assistance for replacement or exchange of defective components is available. In addition, if your IBM option is installed in an IBM computer, you might be entitled to service at your location. Your technical support representative can help you determine the best alternative.
Page 24
For the support telephone number and support hours by country, refer to the following table. If the number is not provided, contact your IBM reseller or IBM marketing representative. Response time may vary depending on the number and nature of the calls received.
If a Machine does not function as warranted during the warranty period, and IBM or your reseller are unable to either 1) make it do so or 2) replace it with one that is at least functionally equivalent, you may return it to your place of purchase and your money will be refunded.
Page 26
IBM or your reseller will 1) either repair or exchange the failing Machine and 2) provide the service either at your location or a service center. IBM or your reseller will also manage and install selected engineering changes that apply to the Machine.
Page 27
IBM or your reseller of changes in a Machine’s location. IBM is responsible for loss of, or damage to, your Machine while it is 1) in IBM’s possession or 2) in transit in those cases where IBM is responsible for the transportation charges.
Page 28
APPLY TO YOU. Governing Law Both you and IBM consent to the application of the laws of the country in which you acquired the Machine to govern, interpret, and enforce all of your and IBM’s rights, duties, and obligations arising from, or relating in any manner to, the subject matter of this Agreement, without regard to conflict of law principles.
Page 29
Limitation of Liability: The following is added to this Section: Where IBM is in breach of a condition or warranty implied by the Trade Practices Act 1974 or other similar legislation, IBM’s liability is limited to the repair or replacement of the goods or the supply of equivalent goods.
Page 30
2. as to any other actual damage arising in any situation involving nonperformance by IBM pursuant to, or in any way related to the subject of this Statement of Limited Warranty, IBM’s liability will be limited to the charge paid by you for the individual Machine that is the subject of the claim.
Page 31
PEOPLE’S REPUBLIC OF CHINA (PRC) Governing Law: The following replaces this Section: Both you and IBM consent to the application of the laws of the State of New York (except when local law requires otherwise) to govern, interpret, and enforce all your and IBM’s rights, duties, and obligations arising from, or relating in any manner to, the subject matter of this Agreement, without regard to conflict of law principles.
Page 32
(1) an IBM reseller approved to perform warranty service or (2) from IBM. If you purchase an IBM Machine in a Middle Eastern or African country, you may obtain warranty service for that Machine from the IBM entity within the...
Page 33
The minimum warranty period for Machines is six months. In case IBM or your reseller is unable to repair an IBM Machine, you can alternatively ask for a partial refund as far as justified by the reduced value of the unrepaired Machine or ask for a cancellation of the respective agreement for such Machine and get your money refunded.
Page 34
Limitation of Liability: The following replaces item 2 in this Section: as to any other actual direct damages, IBM’s liability will be limited to the total amount you paid for the Machine that is the subject of the claim. For purposes of this item, the term “Machine”...
Page 35
The following item is added to this paragraph: 3. breach of IBM’s obligations implied by Section 12 of the Sale of Goods Act 1979 or Section 2 of the Supply of Goods and Services Act 1982.
Page 36
IBM may use or distribute any of the information you supply in any way it believes appropriate without incurring any obligation to you.
IBM. You should contact the vendors responsible for those products directly to determine the capabilities of their products and update them if needed. This IBM hardware product cannot prevent errors that might occur if software, upgrades, or peripheral devices you use or exchange data with do not process date data correctly.
Page 38
Properly shielded and grounded cables and connectors must be used in order to meet FCC emission limits. Proper cables and connectors are available from IBM authorized dealers. IBM is not responsible for any radio or television interference caused by using other than recommended cables and connectors or by unauthorized changes or modifications to this equipment.
Page 39
Directive 89/366/ECC on the approximation of the laws of the Member States relating to electromagnetic compatibility. IBM can not accept responsibility for any failure to satisfy the protection requirements resulting from a non-recommended modification of the product, including the fitting of non-IBM option cards.
Page 40
IBM no puede aceptar responsabilidad alguna si este producto deja de satisfacer dichos requisitos de protección como resultado de una modificación no recomendada del producto, incluyendo el ajuste de tarjetas de opción que no sean IBM. Este producto ha sido probado y satisface los límites para Equipos Informáticos Clase B de conformidad con el Estándar CISPR22 y el Estándar Europeo EN...
Page 41
B-17 Appendix B. Product warranty and notices...
Page 42
Part Number: 22P7159 Printed in the United States of America on recycled paper containing 10% recovered post-consumer fiber. (1P) P/N: 22P7159...