Recipient hereby agrees not to disclose, or allow to be disclosed, any Proprietary information or material of Eagle, in whole or in part, to any person or entity, for any reason or purpose whatsoever. Recipient further agrees that Recipient shall not use any Proprietary information or materials of Eagle for Recipient’s own purposes or for the benefit of any other person or entity...
Master Drawing List GA182 DRAWING SHEET REV DATE TOTAL DESCRIPTION G13130-3 5/13/12 MUX Plate LOG OF REVISIONS REVISION DATE OF PAGES DESCRIPTION OF CHANGE APPROVAL LEVEL REVISION Initial Release 4/3/98 All Pages 4/27/98 All Pages TO CORRECT G11262, G11695 REVISION LEVELS 6/18/98 All Pages TO CORRECT REVISION LEVELS.
Page 15
PAGES DESCRIPTION OF CHANGE APPROVAL LEVEL REVISION Incorporated ECO’s 1144, 1428 & 2/9/2009 1432 Adding new P139-HD Digital Audio System, added ICA182-2 & ICA182-3 8/11/2011 Revised RFMS GA182-3, GA182-6 & GA1-9TP for EASA approval; Incorporated ECO’s 1448, 1453, 1471 & 1483 Removed ICA’s and RFMS’...
Page 18
Documents with multiple pages, that have a different revision level on some pages, are listed by individual pages on this list. DOC No. PAGES DATE DESCRIPTION G13004 3/26/14 P139-HD Audio System Wiring Diagrams G13115 3/26/14 Audio Control Panel G13116 3/26/14 Audio Control Panel G13121...
Page 20
P139-HD (S) has been added as an optional system configuration. It uses Router G13000 in a “Single-board” configuration that uses the same case as the dual-board router, but with only one audio board installed. These two routers share the same installation and wiring drawings.
Page 25
DOC No. PAGES DATE DESCRIPTION G13000 8/13/14 P139-HD Router G13160 8/13/14 P139-HD 3 Board Router ECO LOG OF REVISIONS REVISION DATE OF PAGES DESCRIPTION OF CHANGE APPROVAL LEVEL REVISION Initial Release...
Page 35
Geneva Aviation, Inc. www.GenevaAviation.com GA182-8 Revision D, 4/23/2014 P139-HD Digital Audio System Bell 206 / 407 Installation Manual GA182-8 Rev D P139-HD Digital Audio System 1 of 16...
Page 36
INTRODUCTION 1.1. This document provides general information and instructions for the installation of the Geneva P139-HD Digital Audio System, under STC SR00521SE. 1.2. Installation is to be accomplished in accordance with Geneva Aviation instructions. Throughout the installation of this product it is necessary to utilize proper aviation practices.
Page 37
Do not disassemble router or the factory warranty will be voided. For service, return the unit to Geneva Aviation. 1.3. There are three types of P139-HD Audio Systems that the installer may choose to install at their discretion. 1.3.1. P139-HD (D) Uses Router G13000 in a “Dual-board” configuration and is shown in the diagrams and is the router used throughout the instructions.
Page 38
1.10. For Non-Pilot positions, Control Panels G13115NS or G13116NS may be used. The panels do not have an internal COM1, COM2 isolate switch. For these panels, do not connect to the COM1 or COM2 circuits shown in wiring diagrams G13004. GA182-8 Rev D P139-HD Digital Audio System 4 of 16...
2.2. Control Panels G13115 and G13116 may be used interchangeably, depending on the control functions desired and number of radios installed. 2.3. It is the installer’s responsibility to document the system configuration as installed for maintenance purposes. GA182-8 Rev D P139-HD Digital Audio System 5 of 16...
Page 40
Geneva Aviation, Inc. www.GenevaAviation.com Component Installation & Hookup J6 NETWORK PORT J7 MEMORY PORT Figure 2 G13000 Router Connector Layout GA182-8 Rev D P139-HD Digital Audio System 6 of 16...
Page 41
3.1.8. The Router contains no user serviceable internal components. Do not disassemble router or the factory warranty will be voided. Return the unit to Geneva Aviation for service. GA182-8 Rev D P139-HD Digital Audio System 7 of 16...
Page 42
Geneva Aviation, Inc. www.GenevaAviation.com J8 NETWORK PORT J9 MEMORY PORT Figure 3 G13160 Router Connector Layout GA182-8 Rev D P139-HD Digital Audio System 8 of 16...
Page 43
3.2.10. The Router contains no user serviceable internal components. Do not disassemble router or the factory warranty will be voided. Return the unit to Geneva Aviation for service. GA182-8 Rev D P139-HD Digital Audio System 9 of 16...
Page 44
G13162 for the detailed wiring schematic used in this installation. 3.3.5. Be sure to carefully document the Radios and Control panels as installed and their related connections for future maintenance and troubleshooting purposes. GA182-8 Rev D P139-HD Digital Audio System 10 of 16...
Page 45
The G13115NS version does not have an EMERG/NORMAL switch and must not be used as a pilot or copilot primary panel. GA182-8 Rev D P139-HD Digital Audio System 11 of 16...
Page 46
ICS switch and transmit switches on the cyclic and/or foot switches. 3.7.2. For each passenger, a unique Passenger Headset Group is needed. The Passenger Headset Group consists of the passenger’s headset jack, an ICS switch and a transmit switch. GA182-8 Rev D P139-HD Digital Audio System 12 of 16...
Page 47
There is normally no need for any type of universal radio adapter between an audio device and the router. GA182-8 Rev D P139-HD Digital Audio System 13 of 16...
4.2 and 4.3 for Copilot position and COM2 respectively. 4.5. Check all pilot, copilot and passenger audio control panels for proper audio levels and operation. Should adjustments be required, follow the instructions in document GA063-3. GA182-8 Rev D P139-HD Digital Audio System 14 of 16...
Page 49
5.7. Upon satisfactory completion of these load analysis tests, make an aircraft logbook entry that these tests have been performed satisfactorily in accordance with this STC. GA182-8 Rev D P139-HD Digital Audio System 15 of 16...
Page 50
Revised figure in 3.2 to show new style tray 6/25/12 Updated 1.7, & 3.3 for G13115 & G13116 10/15/12 3, 8 Added 1.8; Added G13115NS and G13116NS to 3.3 4/23/14 Added G13160 3-Board Router GA182-8 Rev D P139-HD Digital Audio System 16 of 16...
Page 51
GA1-2TP REV: C 5/13/2012 EMI Test Procedure 19717 62 Ave. South, Suite E-101, Kent, WA 98032 Tel: 800 546 2210 or +1 253 395 9105 Fax 800 546 2220 GA1-2TP Rev C Page 1 of 7...
Page 52
LOG OF REVISIONS DATE OF PAGES DESCRIPTION OF CHANGE APPROVAL REVISION LEVEL REVISION 8/08/1997 Initial Release 9/08/1997 Added “LIST OF REVISIONS” Page 3, 4 Added coverage for FADEC aircraft 10/16/1998 under Scope. Revised procedure under Transponder test 5/13/2012 Revised Scope to remove FADEC references;...
Scope This document is a test plan to be used to establish that newly installed electrical equipment does not interfere with essential aircraft equipment in any way that would impair safety of flight of the aircraft. Satisfactory completion of this test plan confirms that the newly installed equipment satisfies the EMI requirements of the Federal Aviation Administration.
Page 54
Items To Evaluate The following is a list of aircraft systems or components that must be evaluated for the effects of EMI if they are installed and are to be used at the same time as the EUT. If the item listed below is not installed or otherwise not applicable, then mark the N/A __ field.
Page 55
VHF Communications System N/A __ Pass __ Fail __ Tune each comm receiver to a low, middle, and high frequency within its frequency range. Listen for audio interference. Transmit on low, middle, and high frequencies. Listen on an external receiver for audio interference. GPS Navigation Receiver N/A __ Pass __...
Page 57
Aircraft Tested: Model _______________, Registration ___________, Serial Number ______ Location of Test _______________________, Date _____________ Equipment Under Test: List: MODEL, PART NUMBER, SERIAL NUMBER _________________________________________________________________ _________________________________________________________________ _________________________________________________________________ _________________________________________________________________ __________________________________________________________________ __________________________________________________________________ __________________________________________________________________ __________________________________________________________________ Test performed by ________________________________________________ Name Credentials Test witnessed by ________________________________________________ Name Credentials I hereby certify that I have witnessed the above documented test and that the...
Page 59
REVISIONS DESCRIPTION APPROVED/DATE REVISED LABEL ON J7 5/12/09 G13000 P139-HD ROUTER WEIGHT = 5 LBS MAX ADDED SINGLE BOARD CONFIGURATION 6/10/11 NOTE POWER = 5 AMPS MAX J6 NETWORK PORT VOLTAGE = 14 - 32 VDC REVISED FRONT SCREWS FOR G13009 TRAY...
Page 61
REVISIONS DESCRIPTION APPROVED/DATE ADDED P/N G13115NS 10/15/12 REVISED NOTES 3/26/14 4.950 2.995 3.355 2.960 5.740 NOTES: BUTTON LABELS SHOWN ARE FOR REFERENCE ONLY AND ARE INSTALLER DEFINED DRAWN DATE 6/01/12 POWER: 28 VDC @ 250mA MAX BREAK SHARP EDGES DATE CHECKED WEIGHT: 1.50 LBS MAX UNLESS OTHERWISE SPECIFIED...
Page 63
REVISIONS DESCRIPTION APPROVED/DATE ADDED P/N G13116NS 10/15/12 REVISED NOTES 3/26/14 4.950 2.995 3.355 2.230 5.740 NOTES: BUTTON LABELS SHOWN ARE FOR REFERENCE ONLY AND ARE INSTALLER DEFINED DRAWN DATE 6/01/12 BREAK SHARP EDGES POWER: 28VDC @ 250mA MAX DATE CHECKED UNLESS OTHERWISE SPECIFIED P/N G13116 : AS SHOWN WEIGHT: 1.25 LBS MAX...
Page 79
INSTALLATION INSTRUCTIONS HAT RACK DECK THIS INSTALLATION PROVIDES MOUNTING PROVISIONS FOR THE G13000 P139-HD ROUTER IN THE HAT RACK AREA FOR BELL 206 / 407 SERIES HELICOPTERS. LOCATION SHOWN IS FOR REFERENCE ONLY, EXACT PLACEMENT IS DEPENDENT ON OTHER PRE-EXISTING INSTALLED EQUIPMENT.
Page 81
REVISIONS DESCRIPTION APPROVED/DATE 08/13/14 G13160 P139-HD VOLTAGE RANGE WAS 10 - 30 VDC 3 BOARD ROUTER WEIGHT = 5.3 LBS MAX J8 NETWORK PORT POWER = 5 AMPS MAX VOLTAGE = 14 - 32 VDC 10.00 J9 MEMORY CARD SLOT...