Table of Contents
Advertisement
iAquaLink™
Web Connect Device
For use with AquaLink
For use with PDA for Systems with 6.0 Firmware or later
FOR YOUR SAFETY - This product must be installed and serviced by a contractor who is licensed and qualified in
pool equipment by the jurisdiction in which the product will be installed where such state or local requirements exist.
The maintainer must be a professional with sufficient experience in pool equipment installation and maintenance so
that all of the instructions in this manual can be followed exactly. Before installing this product, read and follow all
warning notices and instructions that accompany this product. Failure to follow warning notices and instructions
may result in property damage, personal injury, or death. Improper installation and/or operation will void the warranty.
Improper installation and/or operation can create unwanted electrical hazard which can cause serious injury, property
damage, or death.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in
a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment to an electrical source on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Modifications made to this equipment, which are not authorized by the manufacturer, may void the user's authority
to operate this equipment.
RS for Systems with Rev R Firmware or later
®
installation Manual
WaRninG
attEntion
Advertisement
Table of Contents
Related Manuals for Zodiac iAquaLink
Summary of Contents for Zodiac iAquaLink
- Page 1 Manual iAquaLink™ Web Connect Device For use with AquaLink RS for Systems with Rev R Firmware or later ® For use with PDA for Systems with 6.0 Firmware or later WaRninG FOR YOUR SAFETY - This product must be installed and serviced by a contractor who is licensed and qualified in pool equipment by the jurisdiction in which the product will be installed where such state or local requirements exist.
-
Page 3: Table Of Contents
Some of the features described in this Manual DO NOT apply to all AquaLink RS models. NOTE Section 1. Important Safety Instructions ..4 iAquaLink Apps and Web Interface ....11 4.8.1 Mobile Smart Device Apps ......11 Section 2. Overview of the iAquaLink Web 4.8.2... -
Page 4: Section 1. Important Safety Instructions
Page 4 ENGLISH iAquaLink™ Web Connect Device for AquaLink RS and PDA Control Systems Installation Manual ® Section 1. Important Safety Instructions READ AND FOLLOW ALL INSTRUCTIONS All electrical work must be performed by a licensed electrician and conform to all national, state, and local codes. - Page 5 ENGLISH Page 5 iAquaLink™ Web Connect Device AquaLink RS and PDA Control Systems Installation Manual ® WARNING People with infectious diseases should not use a spa or hot tub. To avoid injury, exercise care when entering or exiting the spa or hot tub.
-
Page 6: Section 2. Overview Of The Iaqualink Web
The iAquaLink Web Connect Device is a configurable revision 6.0 or later. system that can be accessed anywhere internet The iAquaLink system is a scalable system that may be connection is available. It’s an ideal modern system to customized in any of the following ways:... -
Page 7: Section 3. Iaqualink Upgrade
Installation Manual ® Section 3. iAquaLink Upgrade Replacement of the Power Center PCB and Bezel Assembly and CPU The iAquaLink Web Connect Device can be used in Board addition to an already existing AquaLink RS or PDA control system. WARNING... -
Page 8: Section 4. Iaqualink Network Interface Installation
Installation Manual ® Disconnect all terminal bars and input/output Mount the outdoor iAquaLink J-box at least six (6) control signals from the power center PCB and feet (1,8 m) above the ground, at least eight (8) feet bezel assembly and remove it from the power (2,4 m) from any motor or air blowers that may center can. -
Page 9: Indoor Installation
Strip each wire ¼" (6 mm) and connect to the red, 4-pin connector on the power center PCB. A Install the iAqualink J-box at least six (6) feet (1,8 multiplex kit (P/N 6584) may be required if there m) above the ground and at least five (5) feet are more than two (2) cables running to a red, 4-pin (1,5 m) away from other transceiver J-boxes. -
Page 10: To Set Up The Wifi Parameters Using The Onetouch
ON, then you have a connection to the homeowner's WiFi network and Go to SYSTEM SETUP and Select iAQUALINK the iAquaLink is online. It can take up to a minute SETUP. to establish a connection. Enter the homeowner service set identifier (SSID). -
Page 11: Led Status Indicator Lights
RS and PDA Control Systems Installation Manual ® The table below shows how to set the address of the ▪ Go to the Android Market and search Zodiac iAquaLink, for any Android device. ® iAquaLink board. Short means that a jumper is installed. -
Page 12: Section 5. Web Interface Home Screen
This screen displays the current time, date, temperature, and some user defined features. Dialog Boxes As shown in the figure below, the iAquaLink menu screen displays the following layout: These are secondary windows that provide additional information or alerts about an operation in progress. -
Page 13: Section 6. Using The Menu Screen
ENGLISH Page 13 iAquaLink™ Web Connect Device for AquaLink RS and PDA Control Systems Installation Manual ® Section 6. Using the Menu Screen 6.2.1 Date MENU > SET DATE/TIME Menu Screen On the MENU screen, click the SET DATE/TIME button to display the SET DATE/TIME screen. -
Page 14: Schedule
Page 14 ENGLISH iAquaLink™ Web Connect Device for AquaLink RS and PDA Control Systems Installation Manual ® Schedule Second Step - Programming the new device On the SCHEDULE screen, the added equipment will CAUTION be displayed and highlighted in the circuit list. Also, the Make sure DATE and TIME are set up correctly EDIT will be highlighted. -
Page 15: Customize Home
ENGLISH Page 15 iAquaLink™ Web Connect Device for AquaLink RS and PDA Control Systems Installation Manual ® Enter the desired START TIME. Toggle the AM/PM MENU > CUSTOMIZE HOME button to select your choice. Do the same for the STOP From the MENU screen, click the CUSTOMIZE TIME. -
Page 16: Section 7. Troubleshooting
2620 Commerce Way, Vista, CA 92081 1.800.822.7933 | www.ZodiacPoolSystems.com ZODIAC ® is a registered trademark of Zodiac International, S.A.S.U., used under license. All trademarks referenced herein are the property of their respective owners. ©2012 Zodiac Pool Systems, Inc. H0364100 Rev A 1201...