Table of Contents
Advertisement
TO REPLACE DECK BELT
DECK BELT REMOVAL (See Fig. 16 and 17)
•
Park on a level surface. Apply park
brake.
•
Lower the deck into the lowest cutting
position
•
Disengage the tension relief lever from
the lock bracket.
WARNING
Lever is spring loaded. Have a tight grip
on the lever and release slowly.
•
Remove screws from both the left and
right belt shields, and remove shields.
•
Remove any dirt or grass that may have
accumulated around the cutter housings
and entire deck surface.
•
Carefully roll the belt over the top of the
cutter housing pulleys.
•
Remove the belt from around the electric
clutch on the engine shaft.
•
The belt can now be removed.
DECK BELT INSTALLATION (See Figs. 16 and 17)
NOTE:
For ease in installing the deck belt, refer
to the routing decal on the front edge of the
deck.
•
Wrap the deck belt around the electric
clutch that is located on the engine shaft.
•
Push the rest of the belt through the
IZT(Integraded Zeroturn Transaxle)
support and up onto the deck.
•
Starting on the right hand side of the
deck, wrap the belt around the large right
side idler, right cutter housing pulley,
small center idler, center pulley, left side
pulley and then around the large left side
idler.
•
The belt will be loose at this point.
•
Tightly secure the belt tension rod and
reengage it in the lock bracket.
SERVICE AND ADJUSTMENT
FIGURE 16
1. CLUTCH PULLEY
2. 107709 DECK BELT
FIGURE 16A
1. TENSION RELIEF LEVER
39
1
2
1
CZ-20
Hide quick links:
Advertisement
Chapters
Table of Contents
