hit counter script
Download Print this page
Toshiba MK6409MAV User Manual
Toshiba MK6409MAV User Manual

Toshiba MK6409MAV User Manual

2.5-inch hard disk drive

Advertisement

TOSHIBA AMERICA INFORMATION SYSTEMS
STORAGE DEVICE DIVISION
IRVINE, CALIFORNIA
MK6409MAV (HDD2918)
2.5-INCH HARD DISK DRIVE
USER MANUAL
Rev 02
11/2006

Advertisement

loading

Summary of Contents for Toshiba MK6409MAV

  • Page 1 TOSHIBA AMERICA INFORMATION SYSTEMS STORAGE DEVICE DIVISION IRVINE, CALIFORNIA MK6409MAV (HDD2918) 2.5-INCH HARD DISK DRIVE USER MANUAL Rev 02 11/2006...
  • Page 2: Table Of Contents

    CONTENTS Introduction................1 Setup ..................2 Using the HDD .................4 Troubleshooting...............5 Specifications ................6 Drive Connectors..............8...
  • Page 3: Introduction

    13ms Average Seek Time • ATA-4 Interface • 33.3MBs Ultra DMA Transfer Rate • 512KB Buffer • Rotational speed of 4,200rpm • MTTF 300,000 Hours *Toshiba defines a megabyte (MB) as 1,000,000 bytes and a gigabyte (GB) as 1,000,000,000 bytes.
  • Page 4: Setup

    Master/Slave Settings Your Toshiba Hard Disk Drive can be configured as either a "Master" or "Slave" unit. Master configuration is used for all single drive applications, and master or slave configuration (only one of each per port) is used for two drive applications.
  • Page 5 Installation Notes The drive should be mounted carefully on the surface of 0.1mm or less flatness to avoid excessive distortion. In order to prevent short-circuit under any circumstances, a space of 0.5mm or more should be kept under the PCB. Space should be kept around the drive to avoid any contact with other parts, which may occur due to shock or vibration.
  • Page 6: Using The Hdd

    USING THE HARD DISK DRIVE – MK6409MAV (HDD2918) Backing up Data Files To avoid data loss, regularly back up the data files on the hard disk drive.
  • Page 7: Troubleshooting

    Manager DiskGo by Ontrack. Check with your local computer/software supplier for availability or contact the software manufacturer. How do I install my 2.5" Toshiba Hard Drive into my You will need a HDD mounting kit in order to install a desktop or tower system? Toshiba 2.5"...
  • Page 8: Specifications

    Host Transfer Rate Ultra DMA mode 33.3Mbytes/sec PIO mode 16.6Mbytes/sec Interleave Factor *Toshiba defines a megabyte (MB) as 1,000,000 bytes and a gigabyte (GB) as 1,000,000,000 bytes. Internal Drive Characteristics Number of Disks Number of Read/Write Heads Track Density (TPI) 589 (14.9K)
  • Page 9 Shock Operating 100G, 1.5ms half sine wave Non-Operating 500G, 2ms half sine wave Physical Height 0.492" (12.5mm) Width 2.75" (69.85mm) Depth 3.94" (100mm) Weight 5.29oz (150g) typ Regulatory The drive satisfies the following standards: Underwriters Laboratories (UL) 1950 Canadian Standard Association (CSA) C22.2 No.220 No.
  • Page 10: Drive Connectors

    DRIVE CONNECTORS – MK6409MAV (HDD2918) Figure 1.MK6409MAV HDD Rear View - Connectors Interface Connector Drive Side Connector Yamaichi GAP050K11617 or equivalent Recommended Host Side Connector Board Straight type: Berg 86455-044 86456-044 or equivalent Cable Berg 89361-044 or equivalent Recommended Cable Characteristics Standard diameter 0.32mm (28AWG)
  • Page 11 Interface Pin Assignment DRIVE INTERFACE SIGNALS SIGNAL SIGNAL RESET GROUND DD 7 DD 8 DD 6 DD 9 DD 5 DD 10 DD 4 DD 11 DD 3 DD 12 DD 2 DD 13 DD 1 DD 14 DD 0 DD 15 GROUND DMARQ...

This manual is also suitable for:

Hdd2918