Table of Contents
Related Manuals for Kenwood KDC-BT43U
Summary of Contents for Kenwood KDC-BT43U
- Page 1 KDC-BT43U KDC-BT33U CD-RECEIVER INSTRUCTION MANUAL CD-RECEIVER BEDIENUNGSANLEITUNG CD-PECИBEP ИHCTPУKЦИЯ ПO ЭKCПЛУATAЦИИ CD-РЕСІВЕР ІНСТРУКЦІЯ З ЕКСПЛУАТАЦІЇ Изделие изготовлено во Франции © 2012 JVC KENWOOD Corporation GET0859-004A (EF)
- Page 2 The marking of products using lasers Information on Disposal of Old Electrical and Electronic Equipment and The label is attached to the chassis/case and says that the component uses laser Batteries (applicable for EU countries that have adopted separate waste beams that have been classified as Class 1.
- Page 3 • The Bluetooth® word mark and logos are registered trademarks owned by 1000 частин на мільйон; Bluetooth SIG, Inc. and any use of such marks by JVC KENWOOD Corporation is 2. кадмій (Cd)– не перевищує 0.01 % ваги речовини або в концентрації до...
-
Page 4: Table Of Contents
CONTENTS BEFORE USE BEFORE USE Warning Do not operate any function that takes your attention away from safe driving. BASICS GETTING STARTED Caution Volume setting: RADIO • Adjust the volume so that you can hear sounds outside the car to prevent accident. •... -
Page 5: Basics
BASICS Faceplate Remote control (RC-406) KDC - BT43U can be remotely controlled with an Volume knob Attach (turn/press) Loading slot optionally purchased remote control. KDC - BT43U Remote sensor (Do not expose to bright sunlight.) Detach Pull out the insulation sheet KDC - BT33U when using for the first time. -
Page 6: Getting Started
Then, perform steps above to set the clock. F/W UPDATE F/W UP xx.xx YES: Starts upgrading the firmware. ; NO: Cancels (upgrading is not activated). For details on how to update the firmware, see: www.kenwood.com/cs/ce/... -
Page 7: Radio
RADIO Default: XX LOCAL SEEK ON: Searches only FM stations with good reception. ; OFF: Cancels. Selects the tuning method for the 4 / ¢ buttons. SEEK MODE AUTO1: Automatically searches for a station. ; AUTO2: Searches for a preset station. ; MANUAL: Manually search for a station. -
Page 8: Cd / Usb / Ipod
The source changes to USB and playback • AAC/MP3/WMA file: Select the desired folder, then a file. starts. • iPod or KENWOOD Music Editor Light (KME Light)/ KENWOOD Music Control (KMC) file * : Select the desired file from the list (PLAYLISTS,... -
Page 9: Aux
CD / USB / iPod Preparation: Direct Music Search (using RC-406) Set the skip ratio Select [ON] for [BUILT-IN AUX]/ [BUILTIN AUX]. (➜ 4) KDC - BT43U (for KDC - BT43U While listening to iPod (for ) or KME Press DIRECT. Light/ KMC file... -
Page 10: Bluetooth
BLUETOOTH® You can operate Bluetooth devices using this unit. Pair a Bluetooth device When connecting a Bluetooth device to the unit for the first time, perform pairing between the unit and Connect the microphone the device. Once the pairing is completed, the Bluetooth device will remain registered in the unit even if KDC - BT43U you reset the unit. - Page 11 BLUETOOTH® Bluetooth mobile phone Bluetooth mode operations Do this Press to enter Bluetooth mode. Turn the volume knob to make a selection (see the following table), then Receive a call Press or the volume knob or one of the number press the knob.
- Page 12 BLUETOOTH® Default: XX Alphabet Search SETTINGS You can search through the contacts quickly according to the first letter (A to Z), number (0 to 9), or symbol. PAIRING PHONE SELECT/ : Select the phone or audio device to connect or disconnect. •...
-
Page 13: Display Settings
DISPLAY SETTINGS BLUETOOTH® Bluetooth audio player Press the volume knob to enter [FUNCTION]. Store a contact in memory Turn the volume knob to select [SETTINGS], then Operations and display indications may differ You can store up to 6 contacts. press the knob. according to their availability on the connected device. -
Page 14: Audio Settings
AUDIO SETTINGS While listening to any source... PRESET EQ NATURAL/ USER/ ROCK/ POPS/ EASY/ TOP40/ JAZZ/ Press the volume knob to enter [FUNCTION]. POWERFUL: Selects a preset equalizer suitable to the music genre. (Select Turn the volume knob to select [AUDIO CONTROL]/ [AUDIO CTRL], then press the [USER] to use the customized bass, middle, and treble settings.) knob. -
Page 15: More Information
Romeo, Long file name. The unit does not work at Reset the unit. (➜ 3) • You cannot operate iPod if “KENWOOD” or “ ” is • Playable USB device file system: FAT16, FAT32 all. displayed on iPod. - Page 16 TROUBLESHOOTING Symptom Remedy Symptom Remedy “NO DEVICE” appears. Connect a USB device, and change the source to USB again. No Bluetooth device is • Search from the Bluetooth device again. detected. • Reset the unit. (➜ 3) “COPY PRO” appears. A copy-protected file is played.
-
Page 17: Specifications
SPECIFICATIONS FM Frequency Range 87.5 MHz to 108 MHz (50 kHz space) Version Bluetooth Ver.2.1+EDR Certified Usable Sensitivity (S/N = 26 dB) 1.0 μV/75 Ω Frequency Range 2.402 GHz to 2.480 GHz Quieting Sensitivity 2.5 μV/75 Ω Output Power +4 dBm (MAX), 0 dBm (AVE) Power Class (DIN S/N = 46 dB) Maximum Communication Range Line of sight approx. -
Page 18: Installation / Connection
Installating the unit (in-dash mounting) Warning • The unit can only be used with a 12 V DC power supply, negative ground. Do the required • Disconnect the battery’s negative terminal before wiring and wiring. (➜ 17) mounting. • Do not connect Battery wire (yellow) and Ignition wire (red) to the car chassis or Ground wire (black) to prevent a short circuit. -
Page 19: Wiring Connection
D Wiring harness Brown To the terminal that is grounded when either the telephone rings or during conversation. MUTE (To connect the Kenwood navigation system, consult your navigation manual.) (Mute control wire) ( ×1 ) Connecting the ISO connectors on some VW/...