Table of Contents
Advertisement
Reversing The Doors
We recommend that you reverse
doors before switching on for the first
time.
Tools required: Small and medium size
flat and cross-headed screwdrivers, a
pair of pliers.
Spare Parts supplied in the plastic
bag: The following parts, which are
exclusively for left hand side fitted hinge
operation are supplied in a plastic bag
with the appliance:
- Upper door top trim hinge covers –
there are 2 different parts, one for each
side of top trim.
- Upper door middle hinge bushing/
door stopper assembly.
We suggest you keep all the parts
supplied in the plastic bag and also
parts, which have been removed when
reversing doors, in a safe place for
possible future, re-use.
IMPORTANT: We suggest you ask
somebody to help you when moving
the appliance around and to hold doors
when removing / re-fitting hinges and
doors to avoid any injury and damage
to the product.
Please refer to diagrams supplied. To
follow numbers in brackets below, refer
to the main diagram.
1. Switch off the appliance at the socket
outlet and pull out the mains plug.
2. Remove all loose items and fittings
and food, if any, from inside the
appliance and door racks.
3. Gently prise off plastic hinge cover of
upper door top trim and hinge covers
on both sides of front top panel using
a small flat-headed screwdriver. (1)
4. Gently tilt the appliance back
against a strong wall on its rear side
sufficiently to allow the lower hinge
to be removed. Take care to protect
the appliance, your wall and floor
coverings. You can utilise the original
packaging to do this. Once you tilt
the appliance back, check to make
sure the appliance is completely
stable and safe before you carry on.
(2)
5. Unscrew and remove the lower hinge
using a cross-headed screwdriver
while holding the lower door firmly.(3)
6. Remove lower door carefully off the
middle hinge and stand door upright
in a safe place.(4)
7. Open upper door and unscrew
and remove the middle hinge while
holding the upper door firmly. Use a
flat-headed screwdriver. Middle hinge
will need to be rotated 180 degrees
before re-fitting on the opposite side.
(5)
8. Remove upper door carefully off the
upper hinge and stand door upright
in a safe place.(6)
9. Unscrew and remove the upper hinge
using a flat-headed screwdriver.(7)
10. Rotate the upper hinge 180 degrees
and then unscrew and remove the
hinge pin using a pair of pliers and re-
fit to opposite side of hinge.(8)
11. Reposition plugs and hinge pin
bushings on top of doors on the
opposite side of both doors. Use
small flatheaded screwdrivers to
remove plugs and bushings. Take
care not to mark doors.(9)
10
EN
Advertisement
Table of Contents
