Setting Hopper Time; Setting Heater Control - Fujitsu M3099EH Operator's Manual
Image scanner
Hide thumbs
Also See for M3099EH:
- Brochure & specs (2 pages) ,
- Oem manual (228 pages) ,
- Reference manual (63 pages)
Table of Contents
Advertisement
Setting hopper time
When you set the picking time, you must set as follows:
1 In Screen 2, press
for M3099GX/GH) to display HOPPER
TIMER screen. <Screen 36>
2 Press
Mode 2
to display Screen 37.
(The default setting is 7 seconds.)
3 In Screen 37, press
want to change blinks. Then press
until the value you want to select appears.
(The selectable range is from 0 to 30 seconds
in steps of 1 second.)
4 Press
and
Mode 1
display Screen 36. The settings are stored in
EEPROM.
5 When you close the setup mode, press
.
Stop
Setting heater control
When you set the heater control, you must set as follows:
1 In Screen 2, press
for M3099GX/GH) to go to the HEATER
CONTROL screen. <Screen 38>
2 Press
Mode 2
to display Screen 39. If "ON"
is displayed, the heater control will be done.
If "OFF" is displayed, warming-up will finish
within 30 seconds, if necessary. When the
heater is broken, please set "OFF". Each
time
is pressed, "ON" and "OFF"
Mode 1
appear alternately. The setting is stored in
EEPROM automatically.
3 Press
to display Screen 38. When
Mode 2
you close the setup mode, press
7-14
Mode 1
16 times (17 times
until the digit you
Mode 1
Mode 2
at the same time to
Mode 2
Mode 1
17 times (18 times
.
Stop
<Screen 36>
<
<
S E T U P M O D E
H O P P E R
<Screen 37>
H O P P E R
X X
(Blinking)
<Screen 38>
S E T U P M O D E
<
<
H E
A
T E R
<Screen 39>
A
T E R
H E
O N
>
>
T I M E R
T I M E R
S
>
>
T R O L
C O N
C O N
T R O L
Advertisement
Table of Contents
