Table of Contents
Advertisement
Setting Warmer Drawer Controls
Removing
and Replacing
Warmer
Drawer (If equipped)
Le_ Glide
hmow
shied on r_t
glide. Pull up oll le_ lever
while pushir_ down on
Figure I
Figure 2
To Remove
and
Replace Warmer
(Warm & Ready
TM)
Drawer
To Remove Warmer Drawer:
1.
_1_
Turn power off before removing the warmer drawer.
2.
Open the drawer to the fully opened position.
3.
On the right glide you will find a shield attached with a hex-head screw (see
figure 1). Using a 1/4" socket and ratchet remove the shield.
4.
Locate glide lever on each side ofdrawer, pull up on the left glide lever and push
down on the right glide lever.
5.
Pull the drawer away from the range.
To Replace Warmer Drawer:
1.
Replace shield on the right glide of the drawer body.
2.
Pull the bearing glides to the front of the chassis glide (see figure 2).
3.
Align the glide on each side of the drawer with the glide slots on the range.
4.
Push the drawer into the range until levers "click" (approximately 2"). Pull the
drawer open again to seat bearing glides into position. If you do not hear the
levers "click"
orthe bearing glides do not feel seated remove the drawer
and repeat steps 2-4. This will minimize possible damage to the bearing
glides.
NOTE: The Warmer Drawerwi!! NOT operate while in the Self-Clean and ,Oven
Lockout" modes
- '
Electrical Shock Hazard can occur and result in
serious injuryor death. Disconnect appliance from electric power
before cleaning and servicing the warmer drawer.
16
Hide quick links:
Advertisement
Table of Contents
