Showing The Clock (Display); Con'ecting The Clock - JVC FS-X3 Instructions Manual
Compact component system
Hide thumbs
Also See for FS-X3:
- Service manual (71 pages) ,
- Instructions manual (66 pages) ,
- Instructions manual (32 pages)
Table of Contents
Advertisement
Using the Timers
3 Press the SET button.
The minute
digits of the time indication
blink on the dis-
play.
• To return
to the hour
setting,
press
the CANCEL
button.
4 Press the I_ or < button to set the minute.
5 Press the SET button.
"ADJUST
OK!" appears
on the display.
The Clock in-
dicator
(a(a_) remains
lit, Then,
the selecled
time is set
and the seconds
start counting
from 0.
Example:
P_f-=Ti
I I
=-=LI'-:
L.'l-li'
,,
,,,,,
1... i
._.i
i ,
I
Alternates
DRILY OFF?
CAUTION:
• if there is a power failure, the clock loses its
setting. "0:00" and the Clock indicator (J_)
blinks on the display and the clock must be
reset.
Showing
the Clock
(DISPLAY)
OH
,,,J
"_4
L.,4;
,_.,--,
--
-
,,- i,,.m
_.' J(
_,
/t
kI
(clock)
Display the source
(dock is cinceled )
You can show the era-rent time on the display.
TO display
the clock, press the DISPLAY button on the
Remote Control.
To return to the normal display, press 1he same button
I
\111
€15 20
/II\
2 Perform steps 2 to 5 in "Setting
the Clo-
ck" on page 22-23.
again.
•-- [] ..-- =.-..
•"
.
h" -= =--"I
=
m
=meN
mime
Correcting
the Clock
Use the following
method
to correct
any clock shift.
• When the System is in powersaving
mode, nothing ap-
pears on the display. To see the clock, press the DIMMER
button on the Remote Control
• The clock may gain or lose one to two minutes par month.
• Ifthereisapowerfailure,
theclocklosesitssetting,
"0:00"
blinks on the display and the clock must be reset To reset
the clock, see "Setting the Clock" on page 22-23
You can correct
the clock whether
the System
is turned
on or off.
1 Repeatedly
press the CLOCK/TIMER
bu-
tton to show the clock on the display.
Each time you press the button,
the display
changes
as
follows.
Setting
the Daily
Timer
Once you have set the Daily Timer, the timer will be acti-
vated at the same time every day.
The "DAILY" indicalor on the display shows that the Daily
Timer you have set is in effect.
You can set the Daily Timer whether the Syslem is on or off
(but not in power saving mode (See page 11)).
• If you have made a mistake while setting the timer, press
the CANCEL button on the Remote Control. However, this
does not always cancel the current setting. If the CANCEL
button does not work, press the CLOCK/TIMER button on
the Remote Control repeatedly
until the display returns to
the original display, and start from the first step.
23
Advertisement
Table of Contents
