Table of Contents
Advertisement
RX Speed Reference Setpoint #1
RX Speed Reference Setpoint #1
Program
Frequency Settings
Speed Reference Setpoint #1
This parameter is used to set the direction, gain, and bias of the RX input
terminal when the RX terminal is used as the control input while operating in
the Speed Control or the Torque Control mode.
See
RX Speed Frequency Setpoint #1
when used for Speed control.
See
RX Torque Reference Setpoint #1
when used for Torque control.
This parameter sets the RX input level that is associated with
Frequency Setpoint #1
when operating in the Speed control mode or is
associated with the
RX Torque Reference Setpoint #1
Torque control mode.
This value is entered as -100 to +100% of the -10 to +10 VDC RX input signal
range.
RX Speed Reference Setpoint #2
Program
Frequency Settings
Speed Frequency Setpoint #2
This parameter is used to set the direction, gain, and bias of the RX input
terminal when the RX terminal is used as the control input while operating in
the Speed Control or the Torque Control mode.
See
RX Speed Frequency Setpoint #1
when used for Speed control.
See
RX Torque Reference Setpoint #1
when used for Torque control.
This parameter sets the RX input level that is associated with
Frequency Setpoint #2
when operating in the Speed control mode or is
associated with the
RX Torque Reference Setpoint #2
Torque control mode.
This value is entered as -100 to +100% of the -10 to +10 VDC RX input signal
range.
W7 ASD Installation and Operation Manual
Speed Reference Setpoints
for further information on this setting
for further information on this setting
RX Speed
when operating in the
Speed Reference Setpoints
for further information on this setting
for further information on this setting
RX Speed
when operating in the
RX Speed Reference Setpoint #2
RX
Parameter Type — Numerical
Factory Default — 0.00
Changeable During Run — Yes
Minimum — -100.0
Maximum — 100.0
Units — %
RX
Parameter Type — Numerical
Factory Default — 100.00
Changeable During Run — Yes
Minimum — -100.0
Maximum — 100.0
Units — %
117
- Quick Links:
- I/O and Control
Hide quick links:
Advertisement
Chapters
Table of Contents
