Table of Contents
Advertisement
Available languages
Available languages
• Turn machine off if it jams. Belt jams when it digs too
deeply into workpiece. (Motor force keeps it stuck in the
work.)
• Support workpiece with miter gauge, belt platen or work
table.
• Maintain 1/16" m aximum clearance between table and sand-
ing belt or disc.
CAUTION:
Think safety! Safety is a combination of operator
common sense and alertness at all times when tool is being
used.
WARNING:
Do not attempt to operate tool until it is com-
pletely assembled according to the instructions.
Refer to Figure 1.
Check for shipping damage. If damage has occurred, a claim
must be filled with carrier. Check for completeness.
Immediately
report missing parts to dealer.
The sander comes assembled as one unit. Additional parts
which need to be fastened to sander, should be located and
accounted for before assembling.
A Sander
B Miter Gauge Assembly
C Back Stop
D Table
E Stud
F Handle with Washer
Not Shown: Abrasive Disc, Knob (2), Foot (4), Mounting
Bracket (4), M6 x 16 Socket Head Bolt (2), M6 x 16 Hex Head
Bolt (4), M6 Lock Washer (2), M6 Flat Washer (6), M6 Hex Nut
(4), 3 and 5mm Hex Wrench and 13mm Open End Wrench.
C
E
_'B
Figure 1 - Unpacking Sander
Refer to Figures 2 - 6.
CAUTION:
Do not attempt assembly if parts are missing.
Use this manual to order replacement parts.
WARNING:
Do not operate machine until completely assem-
bled. Do not operate machine until you have completely read
and understood this manual.
TOOLS
NEEDED
While assembling or adjusting your belt and disc sander, you
will need the following tools:
• 13mm Wrench
• 3 and 5mm Hex Wrenches
• Combination Square
• Phillips Screwdriver
MOUNT
SANDER
Refer to Figures 2 and 3.
Choose a suitable location to mount the sander. The sander
must be installed in a place with ample lighting and correct
power supply. To install sander:
• The sander must be bolted to a firm, level surface.
• Make sure there is plenty of room for moving the work-
piece. There must be enough room that neither operators
nor bystanders will have to stand in line with the wood
while using the tool. Allow room so that belt assembly can
be positioned horizontally.
• Press a foot onto each corner of the base of the sander.
• Sander can be installed on a workbench or a tool stand
(see Recommended
Accessories, page 13) using bolts, lock
washers and hex nuts, and mounting brackets.
Figure 2 - Insert Mounting Brackets into Slots of
Sander Base
• Figure 3 shows the base dimensions, mounting holes and
required space to allow for table assembly and belt
assembly in horizontal position.
6"
24"
1
1 8 _r
Figure 3 - Base Dimension and Required Space
ATTACH
ABRASIVE
DISC.
Refer to Figure 4, page 4.
• Remove disc cover by loosening and removing four screws.
• Peel protective paper from the back of the abrasive disc.
3
Hide quick links:
Advertisement
Table of Contents
