Removing Drives; Removing An Optical Drive - HP Elite 7500 Microtower Maintenance And Service Manual
Maintenance & service guide hp elite 7300 & 7500 microtower, hp pro 3300 & 3305 microtower hp pro 3300 small form factor
Hide thumbs
Also See for Elite 7500 Microtower:
- User manual (74 pages) ,
- Manual (4 pages) ,
- Illustrated parts & service map (4 pages)
Table of Contents
Advertisement
To verify the type and size of the storage devices installed in the computer, run Computer Setup.
Removing Drives
When installing drives, follow these guidelines:
●
The primary Serial ATA (SATA) hard drive must be connected to the dark blue primary SATA
connector on the system board labeled SATA0.
●
Connect an optical drive to the light blue SATA connector on the system board labeled SATA2.
●
The power cables for the SATA drives connect directly to the power supply. The primary hard
drive connects to the power connector labeled P4. the primary optical drive connects to the
power connector labeled P3.
●
The system does not support Parallel ATA (PATA) optical drives or PATA hard drives.
CAUTION:
If you are inserting or removing a drive, shut down the operating system properly, turn off the
computer, and unplug the power cord. Do not remove a drive while the computer is on or in standby
mode.
Before handling a drive, ensure that you are discharged of static electricity. While handling a drive,
avoid touching the connector. For more information about preventing electrostatic damage, refer to
Electrostatic Discharge Information on page
Handle a drive carefully; do not drop it.
Do not use excessive force when inserting a drive.
Avoid exposing a hard drive to liquids, temperature extremes, or products that have magnetic fields
such as monitors or speakers.
If a drive must be mailed, place the drive in a bubble-pack mailer or other protective packaging and
label the package "Fragile: Handle With Care."
Removing an Optical Drive
CAUTION:
computer.
1.
Prepare the computer for disassembly
2.
Remove the access panel
3.
Remove the front bezel
4.
Rotate the drive cage to its upright position.
118 Chapter 8 Removal and Replacement Procedures Small Form Factor (SFF) Chassis
To prevent loss of work and damage to the computer or drive:
All removable media should be taken out of a drive before removing the drive from the
(Access Panel on page
(Front Bezel on page
38.
(Preparation for Disassembly on page
102).
104).
101).
Hide quick links:
Advertisement
Table of Contents
