Table of Contents
Advertisement
2. Holding the cable by its connector, align the cable end with the SFP module,
Figure 18. Inserting a fiber-optic cable into an SFP module
Removing SFP modules
In some cases you might need to remove an SFP module, either because it is no
longer needed or because you must replace it. If fiber-optic cables are installed,
they must be removed before you can remove the SFP module.
Note: In the illustrations below, the SFPs and cables are shown outside of the
Removing fiber-optic cables
Follow the steps below to remove a fiber optic cable.
1. Press down and hold the lever (see Figure 19) to release the cable latches.
Figure 19. Fiber-optic cable lever and latches
2. Carefully pull on the connector to remove the cable from the SFP module, as
32
SAN16B-2 Installation, Service, and User's Guide
and push it into the SFP (see Figure 18) until the connector clicks in place .
switch's ports for clarity, and are not oriented in the direction that they are
installed in the switch.
Lever
Latches
shown in Figure 20 on page 33.
Hide quick links:
Advertisement
Table of Contents
