Summary of Contents for GE PDW7900P - Profile: Full Console Dishwasher
Page 1
¢,* i¢_¸ i< i i,3Lft_Ll I L, Appliances nstallation instructions Built-In Dishwasher If you have questions, call 800.GE.CARES 1800.432.2737} or visit our website at: www.ge.com BEFORE YOU BEGIN PORTANT.The dishwasher MUST be installed to oliow for future removal from the enclosure if service is Read these instructions completely required.
Installation Preparation PARTS SUPPLIED Side and Top Trim Pieces on some models IN INSTALLATION PACKAGE: Hose Clamp Two #8-18 × 5/8" Phillips special head screws, to Drain Hose secure dishwasher to underside of countertop sides of cabinets, Screw Kit SideMount Kit Junction box cover and #10 he×...
Installation Preparation PREPARE DISHWASHER ENCLOSURE WARNING To reduce the risk of electric shock, fire, or injurg to persons, the installer must ensure that the dishwasher is completely enclosed This Wall Area at the time of installation, ..must be Free _Pipes or wires (V:: 34-1/2"_+ 1//4"...
Installation Preparation PREPARE ELECTRICAL WIRING FORPERSONALSAFETVI " Receptacle : ", before beginning installation. Donot Remove house fuse or open circuit breaker Location --r-k ",, :::::\ Hole(Max,} t]--- this appliance, 8 ''ill :: _,-F_ 3'from an extension cord or adapter plug with ! _: :':::: C a,b', i ne t...
Page 5
Installation Instructions PREPARE HOT WATER LINE STEP 2-CHECK DOOR BALANCE • The line mug enter from either side. rear or floor within the o With dishwasher on the wood skid, check the door balance shaded urea shown in Figure F. bg opening and closing the door.
Installation Instructions STEP 4-REMOVE TOEKICK STEP 6-INSTALL Front of Dishwasher 90 ° ELBOW , Remove the 2 toekick screws • Wrap 90 ° elbow with and toekick. thread seal tape. Set aside for use o Theod 90 ° elbow into in Step 21, the water valve.
Installation Instructions STEP 8-POSITION WATER LINE STEP IO-SLIDE DISHWASHER AND HOUSE WIRING THREE-FOURTHS OF THE WAY INTO CABINET o Position water supply line and house wiring on the floor of the opening to avoid interference with bose of dishwasher DO NOT PUSH AGAINST FRONT PANEL WITH KNEES. DAMAGE end components under dishwasher, WILL OCCUR, •...
Installation Instructions h_¸ STEP 12-INSTALL SIDE-MOUNT STEP 14-LEVEL DISHWASHER BRACKETS (included with IMPORTANT- oishwosher must beIevel forproper some models) dish rack operation and wash performance. • Place level on door and lower rock track as shown. Check to Skip this step if underside of countertop is wood or wood-like...
Page 9
Installation Instructions STEP 15-POSITION DISHWASHER, SECURE TO COUNTERTOP OR CABINET Method 2 In this step gou will need the 2 Phillips special head screws from the screw kit set aside in Step 1. The dishwasher must Secure dishwasher to cabinet sides be secured to the countertop or the cabinet sides.
Page 10
Installation instructions STEP 17-CONNECT DRAIN LINE DRAIN LINE INSTALLATION FOLLOW ALL LOCAL CODES AND ORDINANCES..° Connect drain line to air gap, waste tee or disposer using the" The motded end of the drain hose will fit 5/8" through 1"...
Installation Instructions STEP 18-CONNECT POWER SUPPLY STEP 19-PRETEST CHECK LIST If a power cord with plug is already installed proceed to Review this list after installing your dishwasher to avoid Step 19. charges for a service call that is not covered by your In this step you will need the junction box cover and the warranty.