Table of Contents
Advertisement
Note
The domain suffix is sent to the DHCP server as FQDN
(Fully Qualified Domain Name) information when Host
name is set.
HTTP port number
Normally select 80. If you want to use a port number
other than 80, select the text box and type a port number
between 1024 and 65535.
Note
When you have set the HTTP port number to a number
other than 80 in the Network menu or in SNC toolbox,
access the system again by typing the IP address of the
camera on your Web browser as follows:
Example: Setting port number 8000 when IP address is
192.168.0.100
IPv6 setting
Configure the IPv6 network settings.
IPv6 can be used simultaneously with IPv4.
Only IPv6-specific details are explained here. For
common details, see "IPv4 setting" on page 38.
On/Off
To use IPv6, select On.
Prefix
Enter the Prefix value. (0 to 128)
MTU
Enter the MTU value. (1280 to 1500)
OK/Cancel
See "Buttons common to every menu" on page 27.
QoS Tab
In the QoS tab, traffic priority can be set by configuring
the number, network address, subnet (prefix), port,
protocol and/or DSCP of IPv4 or IPv6.
A maximum of 10 addresses (No.1 to No.10) can be
registered.
IPv4 QoS setting
Select On to configure the QoS setting for IPv4.
Rule
Used to register, edit and delete QoS.
No.
Select the number to use when registering on the QoS
table.
When you select a registered number, the registered QoS
information is displayed.
Network address
Enter the address to perform QoS.
Subnet
Enter the subnet mask.
Port
Enter the port number.
Protocol
Select the protocol.
DSCP
Enter the DSCP value.
Configuring the Network — Network Menu
39
Hide quick links:
Advertisement
Table of Contents
