Make Electrical Connections-Direct Wire Method - Whirlpool WDF550SAAB Installation Instructions Manual
Undercounter dishwasher
Hide thumbs
Also See for WDF550SAAB:
- User instructions (16 pages) ,
- Energy manual (2 pages) ,
- Installation instructions manual (29 pages)
Table of Contents
Advertisement
Available languages
Available languages
2. If direct wired, check that the power supply wire is on the
right-hand side at the front of the cabinet opening.
If using a power supply cord, insert the power supply cord
through the hole cut in the cabinet wall.
3. Check that the water supply line is on the left-hand side of the
cabinet opening.
4. Check that the drain hose is near the center and insert the drain
hose through the hole in the cabinet .
5. Slowly move the dishwasher into place inside the cabinet
opening with the front corners of the dishwasher door flush
with the cabinet doors.
NOTES:
Do not kink or pinch the copper tubing, drain hose, power
supply cord or the direct wire between the dishwasher and
the cabinet.
Do not remove the insulation blanket from dishwasher to
allow the dishwasher to fit easier into the cabinet opening.
The insulation blanket reduces the sound level when the
dishwasher is operating.
6. If needed, support the front of the dishwasher by raising,
lowering or shimming the front legs.
7. Remove cardboard from beneath the dishwasher.
Level the Dishwasher
1. Align the front of the dishwasher door panel with the cabinet
doors by adjusting the front legs using the 6" adjustable
wrench.
2. Check that the leveling legs are firmly against the floor.
3. Close and latch the dishwasher door.
4. Place a level against the front panel above the leg to check
that the dishwasher is plumb. If needed, adjust the leveling leg
or add shims until the dishwasher is plumb.
NOTE: Shims must be securely attached to the floor to avoid
their movement during dishwasher operation.
5. Repeat for the other side of the dishwasher.
6. Place the level against the top front opening of the tub. Check
that the dishwasher is level from side to side. If the
dishwasher is not level, adjust the front legs up or down until
the dishwasher is level.
Make Electrical Connections—
Direct Wire Method
Review "Electrical Requirements" before continuing.
WARNING
Electrical Shock Hazard
Electrically ground dishwasher.
Connect ground wire to green ground connector in
terminal box.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
1. Route the direct wire so that it does not touch the dishwasher
motor or lower part of the dishwasher tub.
2. Pull cable through UL listed / CSA approved strain relief in
erminal box. Strain relief is not provided with dishwasher.
Owner must purchase a 7/8" screw-in type strain relief.
3. Using twist-on connectors sized to connect direct wire to
16-gauge dishwasher wire, connect the white wire from the
power supply to the white wire on the terminal box.
4. Using twist-on connectors sized to connect direct wire to
16-gauge dishwasher wire, connect the black wire from the
power supply to the black wire on the terminal box.
5. Using twist-on connectors sized to connect direct wire to
16-gauge dishwasher wire, connect the ground wires from the
power supply to the green ground dishwasher wire.
11
Hide quick links:
Advertisement
Table of Contents
