Advertisement
Quick Links
Advertisement
Related Manuals for Beko BDIN38571C
Summary of Contents for Beko BDIN38571C
- Page 1 Dishwasher User’s Manual BDIN38571C 15 7946 0100_AA_BEKO_E9H_EN/ 24-10-23.(13:25)
- Page 2 Dear Customer, Please read this user manual before using the product. Thank you for choosing this Beko product. We hope that you get the best results from your product which has been manufactured with high quality and state-of-the-art technology. Therefore, please read this entire user manual and all other accompanying documents before using the product.
- Page 3 CONTENTS 1 SAFETY INSTRUCTIONS Ceiling cutlery basket ........28 Ceiling cutlery basket ........28 Intended Use ............. 4 Safety for children, vulnerable persons and pets 4 6 OPERATING THE PRODUCT 29 Electrical safety ..........5 Transportation Safety ........5 Programme Selection / Programme Cancel key 29 Installation Safety ..........
- Page 4 This product must be used to Safety Instructions do the domestic type dishes • This section contains safety only. instructions that will help get This product is not suitable for protected against risks of commercial or collective use. personal injury or property damage.
- Page 5 Cleaning and user Do not use extension cords, maintenance works should multi-sockets or adapters to not be performed by children operate the product. unless they are supervised by Plug must be easily someone. accessible. If this is not Keep packaging materials possible, the electrical away from children.
- Page 6 squeezed or crushed while serious burns and injuries, placing the product into its and harm your furniture. location after installation or Do not install the product cleaning procedures. close to heat sources (heater, stove and etc.) or under the Installation Safety cooking area of a hob.
- Page 7 hose set. Do not make extension baskets. Do not sit or put at the hoses. other loads on the door; otherwise, the product may NOTICE Connect the water inlet tilt. hose directly to the water tap. Maximum washing capacity Pressure coming from the tap of the product is stated in the should be 0.03 MPa (0.3 bars) section called “Technical...
- Page 8 Maintenance and cleaning Heat Pump safety For models equipped with a heat Do not wash the product by pump: spraying or pouring water on Make sure that the air intake of the dishwasher is open and well ventilated. Do not use sharp or abrasive tools to clean the product.
- Page 9 General Information on Your machine belongs to the Heat Pump latest environmentally friendly product range category. In order to prevent (R600A) has been used in performance loss depending the heating system of your on the ambient temperature, machine. There are natural the resistance heater may be materials in your machine activated along with the heat...
- Page 10 Environmental Package information Packaging materials of Instructions the product are Compliance with WEEE manufactured from Directive and Disposing of recyclable materials in the Waste Product accordance with our National Environment Regulations. Do not This product complies with dispose of the packaging EU WEEE Directive (2012/19/ materials together with the EU).
- Page 11 Technical specifications Note for test institutions: Data required for performance tests shall be provided upon request. Requests can Maximum washing capacity (check the be e-mailed to the following address: energy label and Programme data and dishwasher@standardloading.com average consumption values table given Do not forget to provide the code, stock on Quick Guide.
- Page 12 Your dishwasher Overview 1. Upper basket 2. Upper impeller 3. Lower impeller 4. Cutlery basket (depends on model) 5. Door 6. Rating Label 7. Control panel 8. Detergent dispenser 9. Lower basket 10. Filters 11. Salt reservoir lid 12. Upper basket rail 13.
- Page 13 Installation Appropriate installation location In the area where this product is Read “Safety Instructions” section first! installed, there must not be a lockable, Installation procedures must always be sliding or hinged door that will restrict performed by the manufacturer, authorised full opening of the product’s door.
- Page 14 Aquasafe+ Permitted water temperature: up to 25°C ( 60°C for products equipped (depends on the model) with Aquasafe+; please refer to The Aquasafe+ system protects against Aquasafe+ section ) water leaks that may occur at the hose The dishwasher may not be connected to inlet.Water contact with the valve box of open warm water devices or flow-through the system must be avoided to prevent...
- Page 15 Connection to the drain Electrical connection Water discharge hose can directly be Connect the product to a grounded connected to the drain hole or sink’s outlet protected by a fuse complying drainage. See the installation manual with the values in the "Technical supplied with your machine for detailed specifications"...
- Page 16 Preparation Read “Quick Guide - Adjusting Water Softening System” before this section! The regeneration of the water softening Read “Safety Instructions” section first! system can be done in all programmes Tips for energy saving during drying step. When regeneration occurs, duration, energy and water Following information will help you use the consumption of the programme increase.
- Page 17 Adding salt Water softening system needs to be regenerated in order for the product to operate with the same performance continuously. Dishwasher salt is used for this purpose. Use only special softening salts produced particularly for the dishwashers in your machine. You can put about 2 kg of softening It is recommended to use granule- or salt into the salt reservoir.
- Page 18 Do not put solvents into the detergent dispenser. There is the risk of explosion! Put the detergent into the detergent dispenser just before operating the machine as illustrated below. 1. Push the latch to right to open the detergent dispenser lid (A). (depends on model) 3.
- Page 19 Tablet detergents 3. After the empty washing cycle, review the user manual and readjust the water In addition to the conventional tablet hardness level so as to suit the water detergents, there are also commercially supply. available detergent tablets that show water 4.
- Page 20 Decorative prints of chinaware as well 3. Slightly press the point (B) of the as aluminium and silver items may get reservoir lid to close it. discoloured or tarnished after washing in the dishwasher just as it happens in handwashing as well. Some delicate glass types and crystals may become dull in time.
- Page 21 Suggestions for loading the dishwasher Improper Loading Of Dishware Lower basket Upper basket Improper Loading Of Dishware 21/EN...
- Page 22 Cutlery basket Cutlery basket (depends on model) (depends on model) Cutlery basket is designed to wash your Cutlery basket is designed to wash your dishes such as knife, fork, spoon, etc. in an dishes such as knife, fork, spoon, etc. in an efficient manner.
- Page 23 Tray Washing Support Collapsible lower basket tines (depends on model) (depends on model) You may use the tray washing supports There are foldable tines (A) located at if you want to wash a tray on your lower the lower basket of the machine are basket.
- Page 24 SoftTouch Accessory Tray Wash Supports (depends on model) (depends on model) The SoftTouch Accessory found in the Use the supports to wash trays in the lower basket of your machine enables a bottom basket. safe washing for your fragile glasses. See the Auxiliary functions section for appropriate programme and function selection.
- Page 25 Collapsible upper basket wires Bottle and Dish Holder on the Lower Basket (depends on model) You can use collapsible wires when you (depends on model) need a larger space for your dishes in the Bottle and dish holder (A) on the lower upper basket of your machine.
- Page 26 Adjusting the height of the upper 1. To raise the basket, hold the wires of the basket and pull the basket upwards basket with both hands while the basket is at (depends on model) the lowermost position (B) Upper basket height adjustment 2.
- Page 27 Adjusting the height of the upper To lower the basket, while it is in the uppermost position; basket 1. Hold the upper basket wires with both (depends on model) hands, slightly lift up the basket and The upper basket height adjustment simultaneously push and release the mechanism has been designed for you to latches shown in the figure (B).
- Page 28 Ceiling cutlery basket (depends on model) Ceiling cutlery basket is designed to wash your cutlery items such as forks, spoons and etc. by placing them between the bars on the basket. When the central tray is in the lower position, you can load long/high items such as coffee cups, ladles, etc.
- Page 29 Operating the product 3. Make sure that the upper and lower Read “Safety Instructions” section first! impellers rotate freely. Read “Quick Quide” before this 4. Put adequate amount of detergent into section. the detergent dispenser. When you press the On/Off key, the Programme selection indicator lights illuminate on the display 1.
- Page 30 Hygiene Intense function Tablet detergent function (depends on the model) (depends on model) Designed to be used when more hygiene Allows to obtain a better drying is required for washing the dishes. This performance from the multi-purpose function increases the washing and rinsing detergents called as all in one detergents temperatures in the selected cycle and such as 2in1, 3in1, 4in1, 5in1 and etc.,...
- Page 31 Changing SelfDry Settings Interior Lighting 1. Press Menu key for 3 second after (depends on the model) turning on your machine. Some models have interior lighting to illuminate the interior when the door is 2. Use the <- and +> keys to move to “o:” opened.
- Page 32 Scheduling the washing time Tablet Detergent Function Off/On Time Delay If an economical electricity tariff is applied in your region, you can use the Time Delay function to wash your dishes during appropriate hours. You can delay the start of the selected programme until 24 hours.
- Page 33 There might be residues of detergent You can select and start a new or rinse aid in the machine and/or on programme following the cancellation the pieces being washed depending of Time Delay function. on the step the programme you have Time Delay function cannot be set after cancelled was in.
- Page 34 Overflowing warning End of programme If the machine intakes too much water or When the programme you have there is leakage at any of the components selected comes to an end, an audible then the machine will detect this and E:01 warning signal will warn you to turn off icon will flash on the Programme indicator.
- Page 35 Maintenance and Cleaning the filters cleaning Clean the filters at least once a week in order for the machine operates efficiently. Read “Safety Instructions” section first! Check if food residues are left on the filters. Unplug the product and turn off the If there are food residues on filters, take tap before attempting any cleaning them out and clean well under running...
- Page 36 Cleaning the hose filter Damages on the machine that may be caused by impurities coming from the urban supply water or your own water installation (such as sand, dirt, rust, etc.) can be prevented by means of the filter attached to the water inlet hose. Check the filter and the hose regularly and clean them if necessary.
- Page 37 Cleaning the impellers Clean the impellers at least once a week in order for the machine operates efficiently. Lower impeller Do not try to rotate the impeller by Check if the holes on the lower impeller (1) holding its ends. Trying to rotate the are clogged.
- Page 38 Troubleshooting Machine does not start. • Power cable is unplugged. >>> Check if the power cable is plugged in. • Fuse is blown. >>> Check the fuses in your house. • Water is cut. >>> Make sure that the water inlet tap is open. •...
- Page 39 • Rinse aid is not sufficient. >>> Check the rinse aid indicator and add rinse aid if necessary. Increase the rinse aid setting if there is enough amount of rinse aid in the machine. • Machine is unloaded right after the programme is over. >>> Do not unload your machine right after washing process is completed.
- Page 40 There is a different odour in the machine A new machine has a peculiar odour. It will fade out after a couple of washes. • Filters are clogged. >>> Check if the filter system is clean. Clean the filter system regularly as illustrated in section “Cleaning and Care”.
- Page 41 • Opening of the detergent dispenser lid is prevented during washing. >>> Place the dishes in a way that will not prevent the detergent dispenser lid from opening and the water going into the machine from impellers. • Detergent is stored under unsuitable conditions. >>> If you are using powder detergent, do not store the detergent package in humid places.
- Page 42 Foam forms in the machine. • Dishes are washed with hand-wash detergent by hand but not rinsed before placing them into the machine. >>> Hand-wash detergents do not contain antifoam. There is no need to hand-wash the dishes before placing them into the machine. Removing the coarse soil on the dishes under tap water, with a tissue paper or fork will be sufficient.