Table of Contents
Advertisement
Installation surface
A concrete floor is the most suitable in-
stallation surface, being far less prone to
vibration during the spin cycle than
wooden floorboards or a carpeted sur-
face.
The machine must be level and se-
curely positioned.
To avoid vibrations during spinning,
the machine should not be installed
on soft floor coverings.
If installing on a wooden joist floor:
Install the machine on a plywood
base (at least 70 x 60 x 3 cm). The
base should span several joists and
be bolted to the joists and not only to
the floorboards.
Tip: If possible, install the machine in a
corner of the room. This is usually the
most stable part of the floor.
Removal of transit bars
Removing the left-hand transit bar
Push the cover out and turn the
transit bar 90° using the open span-
ner supplied.
Pull out the transit bar.
Installation
71
Advertisement
Table of Contents
