Table of Contents
Advertisement
Language
Language menu
Set languages
Display brightness
Operation/display
The display can be set to appear in one of several different lan-
guages. To select the permanent supervisor language you want, go to
the Languages sub-menu.
When a programme is running, you can change the user language us-
ing the sensor control.
The display can be set to one of several different user languages. This
setting allows you to determine how languages can be selected.
International
6 languages are available. The sensor control is not active. Note
the setting
Set languages
Language selection
The sensor control can be used to select a language. All lan-
guages are available (factory default).
You can change the order of the first 4 languages. These slots are al-
located to the most commonly used languages.
Standard language
The user language cannot be changed. The user language is the same
as the supervisor language. The sensor control is not active.
The languages for the setting
changed.
6 languages can be selected. All languages are available.
If you wish to add a new language to the language menu:
First select the language you want to replace.
All available languages are displayed.
Select and confirm the language to replace the previous language.
The new language appears instead of the old one.
The brightness of the display can be altered. The setting depends on
the various lighting conditions in the place of installation.
It can be set to one of 10 different levels.
.
Language entry International
Supervisor level
can be
53
Advertisement
Table of Contents
