IBM 5100 Maintenance Analysis Procedures page 14
Hide thumbs
Also See for 5100:
- Maintenance information manual (389 pages) ,
- Maintenance information (388 pages) ,
- Apl reference manual (228 pages)
Table of Contents
Advertisement
C
1
TAPE READ MAP
PAGE
2 OF
45
003
The characters DCP2 are displayed when the
tape read diagnostic is done.
Are the characters DCP2 displayed?
Y N
004
The instruction PRESS EXECUTE,R,OR L
might be displayed near the bottom of the
display.
Ignore
this
instruction
if
it
is
displayed.
Are
instructions
(other
than
PRESS
EXECUTE,R,OR L) or questions displayed?
Y N
005
Please observe again for:
1. PROCESS CHECK Light on.
2. Error displayed.
3. Instructions or questions displayed.
Do
you
have
any
of
the
above
conditions?
Y N
006
Have you passed this step before?
Y N
3 333 2
D E F G H
H
2
MAP 0300-2
007
(Entry Point B)
-If there is a cartridge in the tape drive, remove
i~.
-Press RESTART and wait 10 seconds.
Use the keys in the numeric key section of the
keybol;lrd (refer to 250 for the location of the
numeric key section).
-Hold CMO and press HOLD.
-Hold CMD and pres!! - (minus)
You have now loaded DCP1 (diagnostic cOntrol
program 1. Refer to section 3,diagnostic aids).
If the DCP1 program load is ok, the char;:lcters
DCP1 are displayed.
Are the characters OCP1 displayed?
Y N
3
J
008
Is the PROCESS CHECK light on?
Y N
009
Go
to MAP 0900, Entry Point A.
010
Go to MAP 0420, Entry Point A.
28SEP76
PN 1608386
EC 829670
PEC 828851
MAP 0300-2
c
Advertisement
Chapters
Table of Contents
