Table of Contents
Advertisement
Removing and replacing the M.2 flash storage module
To remove the M.2 flash storage module:
1.
Remove/disengage any security devices that prohibit opening the thin client.
2.
Remove all removable media, such as USB flash drives, from the thin client.
3.
Turn off the thin client properly through the operating system, and then turn off any external devices.
4.
Disconnect the AC power cord from the AC outlet, and disconnect any external devices.
CAUTION:
the system is plugged into an active AC outlet. You must disconnect the AC power cord to avoid damage
to the internal components of the thin client.
5.
Remove the stand from the thin client.
6.
Lay the unit flat on a stable surface with the right side up.
7.
Remove the thin client access panel. See
8.
Locate the M.2 socket for flash storage module on the system board. See
on page
9.
Loosen the screw securing the flash storage module until the end of the module can be raised.
10.
Pull the flash storage module out of the socket.
Regardless of the power-on state, voltage is always present on the system board as long as
8.
Removing and replacing the access panel on page
Removing and replacing the M.2 flash storage module
5.
Locating internal components
9
Advertisement
Table of Contents
Troubleshooting
