GUARANTEE CONDITIONS INSTALLATION INSTRUCTIONS ELECTRICAL CONNECTIONS INSTALLING THE COOKER HOOD Welcome to the world of Electrolux Thank you for choosing a fi rst class product from Electrolux, which hopefully will provide you with lots of pleasure in the future. The Electrolux...
• Under no circumstances should you attempt to repair the appliance yourself. Repairs carried out by inexperienced persons may cause injury or more serious malfunction. Refer to your local Electrolux Service Force Centre. Always insist on genuine spare parts.
6 electrolux YOUR APPLIANCE AND OPERATING INSTRUCTIONS OPERATING INSTRUCTIONS The cooker hood is designed to extract unpleasant odours from the kitchen, it will not extract steam. The hood can be switched on pushing directly onto the requested speed without fi rstly having to select 0/1 button.
Page 7
fi re. Do not leave naked fl ames under the cooker hood. Ensure heating areas on your hob are covered with pots and pans when using the hob and cooker hood simultaneously. mode electrolux 7...
8 electrolux MAINTENANCE AND CLEANING MAINTENANCE AND CLEANING Before carrying out any maintenance or cleaning isolate the cooker hood from the mains supply. The cooker hood must be kept clean, as a build up of grease or fat can be a fi...
Page 9
fi l- ters are not cleaned and replaced as recommended. Alarm signal reset • Stop the motor. • Press the touch control F for at least 4 seconds, until the touch control T1 fl ashes. electrolux 9 washed saturated activated...
Page 10
10 electrolux MAINTENANCE AND CLEANING Changing the halogen light • Remove the 2 screws fi xing the Lighting support, and pull it out of from the Hood. • Extract the lamp from the Support. • Replace with another of the same type, making sure that the two pins are properly inserted in the lamp holder socket holes.
• Tum off the hob and then wait for the device to reset. In-guarantee customers should ensure that the above checks have been made as the engineer will make a charge if the fault is not a mechanical or electri- cal breakdown. electrolux 11...
12 electrolux GUARANTEE/CUSTOMER SERVICE GUARANTEE/CUSTOMER SERVICE Standard guarantee conditions We, Electrolux, undertake that if within 12 months of the date of the purchase this Electrolux appliance or any part thereof is proved to be defective by reason only of faulty workmanship or...
• The appliance is installed and used accordance with issued by Electrolux and is only used within the home, i.e. is not used for commercial purposes. • The appliance accordance...
For more detailed information about recycling of this product, please contact your local city offi ce, your household waste disposal service or the shop where you purchased the product. INSTALLATION INSTRUCTIONS (LOWER SECTION) 220-240 V 50Hz (3 x 20 W) electrolux 15 60mm 465mm 740mm 898mm 490mm...
16 electrolux ELECTRICAL CONNECTIONS ELECTRICAL CONNECTIONS This appliance must be earthed Electrical Requirements Any permanent electrical installation must comply with the latest I.E.E. Regulations and local Electricity Board regulations. For your own safety this should be undertaken by a qualifi ed electrician e.g.
Unpacking Before unpacking the cooker hood position the carton with the arrows pointing upwards as illustrated on the carton. INSTALLING THE COOKER HOOD electrolux 17...
Page 18
18 electrolux INSTALLING THE COOKER HOOD The cooker hood is made up of the following components: Ref Qty Product Components Hood body, complete with controls, lighting, fan and fi lters. Telescopic Chimney comprising: Upper section Lower section ø150-120 Ducting spigot ø120-125 Ducting fl...
Page 19
The hood is supplied suitable for recirculation with the charcoal fi lters fi tted. When used in the extraction mode (ducting) the charcoal fi lters are not required and must be removed and destroyed. 650mm clearance 700mm clearance 685mm clearance 787mm clearance electrolux 19...
Page 20
20 electrolux INSTALLING THE COOKER HOOD Fitting the Wall Brackets Wall marking: • Draw a vertical line on the supporting wall up to the ceiling, or as high as practical, at the centre of the area in which the hood will be installed.
Page 21
The ducting used must be manufactured from fi re retardent material conforming to the relevant British Standard or DIN 4102-B1. When the cooker hood is ducted to the outside the charcoal fi lter must be removed. INSTALLING THE COOKER HOOD electrolux 21...
Page 22
22 electrolux INSTALLING THE COOKER HOOD Recirculation The cooker hood is supplied specifi ed for use in the recirculation mode, with the charcoal fi lter fi tted. In the recirculation mode contaminated air is passed through the charcoal fi lter to be purifi...
Page 23
fi tted ensure that there is an adequa- te supply of air to the room. The cooker ducting (extraction mode) must never be connected to central heating fl ues, radiators or water heaters etc. INSTALLING THE COOKER HOOD electrolux 23...
Page 24
24 electrolux INSTALLING THE COOKER HOOD Electrical Connection and Working Test Before fi tting the chimney to the canopy make the electrical connection as described in the section titled “ELECTRICAL CONNECTION”. When the electrical connection has been made, test the three speed fan and worktop illumination.