Installing The Chassis In A Four-Post Rack - Cisco Nexus 9396PX Hardware Installation Manual
Aci-mode switch
Hide thumbs
Also See for Nexus 9396PX:
- Hardware installation manual (76 pages) ,
- Hardware installation manual (68 pages) ,
- Hardware installation manual (74 pages)
Table of Contents
Advertisement
Installing the Chassis in a Four-Post Rack
Before you begin
• You must have the following tools and equipment:
Step 1
Align the two holes in one side of one of two front-mount brackets to two holes on the left or right side of the chassis
(see the following figure).
Be sure that the other side of the bracket is facing toward the front (port end) of the chassis.
1
Front-mount bracket with two screw holes aligned to
two screw holes in the chassis and one screw hole
facing the front (port side) of the chassis.
Step 2
Use two M4 x 6 mm screws to attach the bracket to the chassis. Tighten each screw to 11 to 15 in-lb (1.2 to 1.7 N·m).
Step 3
Repeat Steps 1 and 2 to attach the second center-mount bracket to the other side of the chassis.
What to do next
You are ready to mount the chassis to the four-post rack.
Installing the Chassis in a Four-Post Rack
You need to slide the chassis onto the bottom-support rails so that the power supply end locks onto the chassis
stops at the end of the rails and so that the front-mount brackets on the chassis come into contact with the
front-mount rails on the rack.
Warning
Cisco Nexus 9396PX ACI-Mode Switch Hardware Installation Guide
22
• Manual Phillips-head torque screwdriver
• Front-mount brackets (2) and screws (4) (found inside the switch accessory kit)
Statement 1074 Comply with Local and National Electrical Codes
To reduce risk of electric shock or fire, installation of the equipment must comply with local and national
electrical codes.
2
Two M4 x 6 mm screws used to fasten the bracket to
the chassis.
Installing the Chassis
Advertisement
Table of Contents
