Table of Contents
Advertisement
Webcam module
The webcam is located at the top of the computer, under a plastic shield. The top heat sink screws also secure
the webcam plastic shield.
To remove the webcam module:
NOTE:
Webcam appearance may vary.
1.
Prepare the computer for disassembly (see
2.
Remove the rear port cover (see
3.
Remove the stand (see
4.
Remove the access panel (see
5.
If a discrete heat sink is installed, remove the VESA mounting bracket/fan assembly (see
bracket/fan assembly on page
6.
Remove the heat sink (see
7.
To remove the webcam plastic shield, remove the two Torx screws (1), and then remove the webcam
shield from the computer (2).
8.
Remove the two Phillips screws (1) that secure the webcam assembly to the computer.
9.
Disconnect the webcam cable from the system board (2).
Preparing to disassemble the computer on page
Removing the rear port cover on page
Stands on page
19).
Access panel on page
38).
Heat sink on page
33).
18).
20).
18).
VESA mounting
Webcam module
35
Hide quick links:
Advertisement
Table of Contents
