Advertisement
Quick Links
1.
Check ceiling area for concealed obstructions such as wiring, plumbing, heating ducts, etc.
2.
Use a "stud finder" to locate positions of joists or rafters. Make sure that your intended locations for your speakers is
unobstructed and that the hole will be at least 2 inches away from joists or rafters.
3.
Use the supplied compass or cut-out template/paint mask to draw a circle with the diameter that corresponds to the model
of your speaker on the chart below, and carefully cut out the hole.
4.
Remove grille from speaker assembly using included grille remover.
5.
Before installation, turn the "Angle Lug Installation Clamps" (Item A) so they are positioned as in photo below. This way,
they will clear the cut-out hole for installation.
Mounting
Models
Dimension
SC-502 E
6 1/2"
SC-520 KE
SC-600
SC-602 E
7 3/8"
SC-620 KE
SC-622 K
SC-800
SC-802 E
8 5/8"
SC-820 KE
SC-822 K
6.
Prior to inserting speaker assembly into cut-out hole, attach speaker wires. Make sure to observe polarity (the "+" and
the "-"). Speakers wired out of phase will exhibit an apparent loss of bass response. The wires will be held in place by
the "Spring Clip Terminals" (Item B). Wires should be stripped about .25". Tinning of wire ends will assure a trouble free
installation, but is not necessary.
7.
Single Point Stereo models have two sets of input terminals. Each speaker location should be wired with a total of four
speaker wires. Attach the pair of wires carrying the Left Channel signal to one set and attach the pair carrying the Right
Channel to the other.
8.
Insert speaker assembly into hole and begin to tighten installation screws. As you start to turn each screw, the "Angle
Lug Clamps" will rotate outward to engage ceiling material (Item C). CAUTION: Do not overtighten the clamps. Too
much torque may snap off the lug, causing the speaker not to seat securely. A snug fit is all that is necessary to assure
proper performance.
9.
If speaker assemblies are to be painted, either before or after installation, use the paint masking template (cardboard
disc) to cover the speaker driver(s) to prevent damage. DO NOT TRY TO PAINT THE GRILLE AND FRAME ASSEMBLY
TOGETHER. The grille should always be painted separately. Use thin coats taking care not to block perforations with
excessive paint.
9.
Your speaker includes a pivoting tweeter and it may be aimed to achieve better imaging. Tweeter output should be
directed toward the typical listening position. USE CARE TO AVOID DAMAGING THE DOME OF THE TWEETER
DURING AIMING!!
Installation of Ceiling Speakers
A
B
OEM Systems Company, Inc.
(775) 355-0405
www.oemsystems.com
C
Rear View of Speaker Assembly
(800) 291-0561 FAX
●
info@oemsystems.com
●
Rev. B
Advertisement
Related Manuals for OEM SC-602E
Summary of Contents for OEM SC-602E
- Page 1 Lug Clamps” will rotate outward to engage ceiling material (Item C). CAUTION: Do not overtighten the clamps. Too much torque may snap off the lug, causing the speaker not to seat securely. A snug fit is all that is necessary to assure proper performance.