Electrical Connection; Cable Shield; Signal Part - ABB Contrac LME620-AI Operating Instruction

Electrical linear actuator

Hide thumbs Also See for Contrac LME620-AI:

Table of Contents

Electrical connection

Each actuator requires a Contrac electronic unit which is loaded with the type specific-software.

Carefully consider the instructions for the electronic unit and compare the data labels of the

actuator and the electronic unit in order to ensure a proper hard- and software assignment.

4.1

4.1.1

Fig. 5: Fitting the shield

1. Remove approx. 2 cm of cable sheathing (3) from the end of the cable.

2. Separate the shield and peel it back to its inner sheathing (4).

3. Push the cable through the cable gland and fasten with clamp (1).

4. Make sure that the shielding is touching the clamp and the electronic unit housing (2).

LME620-AI/-AN (Contrac)

42/68-273-EN

Table of Contents

Contrac lme620-an