WARNING TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS PRODUCT TO RAIN OR MOISTURE DURING INSTALLATION. TO AVOID ELECTRICAL SHOCK, DO NOT OPEN ANY INTERNAL DEVICE AND CABINET INSIDE THE HOUSING OF THE CAMERA. REFER SERVICICE TO QUALIFIED PERSONNEL ONLY. CAUTION: CHANGES OR MODIFICATIONS NOT EXPRESSLY APPROVED BY THE PARTY RESPONSIBLE FOR COMPLIANCE COULD VOID THE USERS AUTHORITY TO OPERATE THE EQUIPMENT.
Spacers (Not used) Cable glands Screws & nuts Hex wrench ANPR Camera XCI-NPR (ANPR = Automatic Number Plate Recognition) Installation Fix the wall mount bracket on the wall (contact your distributor for the selection of the wall mount bracket) Fix the Camera to the wall mount bracket...
CAUTION – RISK OF ELECTRIC SHOCK. Remember to work with mains power disconnected. Connect the Power supply cable and the network cables as described in the section 4. Connection & cabling Connection & Cabling The 3 cable glands (supplied) must be used to ensure housing integrity and compliance to IP66. CAUTION: SWITCH OFF THE 220 VAC POWER LINE Pass the power cable through the cable gland Plug and screw the power cable (NEUTRAL, LIVE and EARTH) as below :...
Page 5
On the plug the cable in the tree connector on the left as shown below, and pass it through the Wiegand Converter cable gland Wiegand RS232 (TX) D0 Data 0 (RX) D1 Data 1 Ground Ground Power can now be connected. CAUTION RISK OF ELECTIC SHOCK – Please observe caution as shown in the areas below when handling the product.
Specifications Technical Features Camera Features Image device 1/3-type progressive scan IT monochrome CCD Effective resolution (H x V) 640 x 480 (VGA) Cell size (H x V) 7.4 x 7.4 µm Frame rate 60 fps (VGA) Electronic shutter 1/250 s to 1/4000 s Processor X86, AMD Geode GX533, 400MHz Operating System...