Table of Contents
Advertisement
1
Select the background video on the cross-point control
block.
Select the video to display before execution of the
transition using the background A bus cross-point
buttons, and the video to display after the transition
using the background B bus cross-point buttons.
2
Select the transition type using the transition type
selection buttons.
For details, refer to step 5 in "Operations on the
transition control block" (page 84).
3
Make the required settings, according to the selected
transition type.
For details, refer to step 6 in "Operations on the
transition control block" (page 84).
4
Carry out the transition in the transition execution
section.
Press the [TAKE] button or operate the fader lever.
Pressing the [TAKE] button executes the transition at
the preset transition rate.
For details, see "Executing a Transition" (page 91).
Note
You can also use the fader lever as split faders (see
page 97).
Key Priority Settings
If a number of keys are already inserted in the current
video, you can check or change the overlay sequence (key
priority).
When a key priority ([KEY PRIOR] button) is selected as
the next transition, you can also change the key priority
when switching to the new video.
The key priority values are from 1 to 4, with a higher
priority key being "in front" as seen on the screen.
Priority 2
Priority 1
Priority 4
Priority 3
You can set the key priority for keys inserted in the current
video and for keys after the transition.
The key priority setting can be set using either the [PRIOR
SET] button in the transition control block, or using the
Misc >Key Priority menu for the M/E or PGM/PST bank.
Note
When the operating mode is set to multi program, the key
priority setting cannot be made.
86
- Quick Links:
- Introduction
- Features
- Setup
Hide quick links:
Advertisement
Table of Contents
