Table of Contents
Advertisement
18
ASSEMBLING AND PREPARING
CAuTION
y When attaching the stand to the TV set, place the
screen facing down on a cushioned table or flat
surface to protect the screen from scratches.
y Make sure that the screws are fastened
completely. (If they are not fastened securely
enough, the TV may tilt forward after being
installed.)
Do not fasten the screws with excessive force
otherwise they may be worn out and become
loose.
NOTE
y Remove the stand before installing the TV on a
wall mount by performing the stand attachment in
reverse.
y Removing the protective film (from the bottom)
(Depending on model)
» Protective film is temporarily attached to
prevent the surface of the product from being
damaged during delivery.
» Once the TV has been installed, please
remove the protective film on the bottom of the
unit as shown in the figure.
Mounting on a table
1
Lift and tilt the TV into its upright position on a table.
- Leave a 10 cm (minimum) space from the wall
for proper ventilation.
10 cm
2
Connect the power cord to a wall outlet.
CAuTION
y Do not place the TV near or on sources of heat,
as this may result in fire or other damage.
Securing the Tv to a table
Fix the TV to a table to prevent from tilting forward,
damage, and potential injury.
To secure the TV to a table, insert and tighten the
supplied screw on the rear of the stand.
(Only
32/42/47/50/60LN570*,
32/42/47/50/60LN572*)
- Quick Links:
- Viewing 3D Imaging (Only 3D Models)
Hide quick links:
Advertisement
Table of Contents
