Connecting The Console Port - Cisco IR8340 Installing And Connecting
Hide thumbs
Also See for IR8340:
- Installation manual (84 pages) ,
- Installing and connecting (10 pages)
Table of Contents
Advertisement
Connecting the Console Port
Connecting the Console Port
To configure the router through the Cisco IOS command-line interface (CLI), you must establish a connection
between the router console port and either a terminal or a PC.
Console Port Connection to a PC
To connect a PC terminal to the console port, use the RJ-45-to-RJ-45 rollover cable, and either the
RJ-45-to-DB-25 female DTE adapter or the RJ-45-to-DB-9 female DTE adapter (labeled TERMINAL ).
The default parameters for the console port are:
• 9600 baud
• 8 data bits
• No parity generated or checked
• 1 stop bit
• No Flow Control
Console Port Signaling and Cabling with a DB-9 Adapter
This section describes the console port signaling and cabling with a DB-9 adapter. See the following figures.
Figure 5: RJ-45 Cable to DB-9 Female Adapter
Figure 6: RJ-45 to RJ-45 Rollover Cable
For the pinout descriptions for the DB-9 connections, see
Console Port Signaling and Cabling with a DB-25 Adapter
This section describes the console port signaling and cabling with a DB-25 adapter as shown in the following
figures.
Installing and Connecting the Router
8
Installing and Connecting the Router
Console Port Adapter
Pinouts.
Advertisement
Table of Contents
