Advertisement
or replacing a new radio system, calibration is needed to obtain the best performance. After calibration, the servos will center, center
rudder of of of of your
rudder
rudder
rudder
your plane
your
your
plane by
plane
plane
by
by adjusting
by
adjusting
adjusting
adjusting the
transmitter
directly
as
as it it it it might
might
reduce
transmitter
transmitter
transmitter directly
directly
directly as
as
might
might reduce
reduce
reduce the
you must get IN 1-2-3 ready.
【 【 【 【 Step
Checking】 】 】 】
Step 7: 7: 7: 7: Before
Step
Step
Before Flight
Before
Before
Flight
Flight
Flight Checking
Checking
Checking
Verify that
Verify
Verify
Verify
that
that
that the
the
the gyro
the
gyro
gyro compensation
gyro
compensation
compensation is is is is in in in in the
compensation
the
the
the
the flight!
flight! Turn on the board, pick the plane up and check it by following the 6 steps shown below:
flight!
flight!
① Rise the head up around the pitch axis, the elevator should flap down accordingly; ② Put the head down around the pitch axis, the elevator should flap up
accordingly. ③ ③ ③ ③ Rotate left around the roll axis, the left aileron should flap down and the other one flap up accordingly; ④ Rotate right around the roll axis, the left
aileron should flap up and the other one flap down accordingly; ⑤ Rotate right around the yaw axis, the rudder should turn left accordingly; ⑥ Rotate left around
the yaw axis, the rudder should turn right accordingly.
If the gyro compensates in an incorrect direction, reverse it by following the instructions of Gyro Reversing Function below.
Map of
Map
Map
Map
of of
of Setting
Setting Methods
Setting
Setting
Methods
Methods
Methods
LED
Indicator
Description
LED Indicator
LED
LED
Indicator Description
Indicator
Description
Description
Condition
Condition
Condition
Condition
Blue, 1 flash after power on
Blue, 2 flashes after power on
Initialization
Blue, 3 flashes after power on
Red, very rapid flashing
Solid Blue
Operating
Solid Red
Both Off
Setting Mode
Red, slow flashing
www.geeetech.com
All manuals and user guides at all-guides.com
Version 1.0
the
the
the length
length
length
length of of of of the
the
the
the linkage
linkage rods,
linkage
linkage
rods,
rods, It It It It is is is is NOT
rods,
the
performance of of of of A3
performance
A3
Pro
the
the performance
performance
A3
A3 Pro
Pro
Pro. Stick Centering works on of aileron, elevator and rudder channels. To enter this function,
the
the correct
the
correct
correct
correct direction
direction
direction
direction for
for the
for
for
the
the
the first-time
first-time installation,
first-time
first-time
LED
LED Indicator
LED
LED
Indicator
Indicator
Indicator
2 / 2
NOT
NOT recommended
NOT
recommended
recommended
recommended to to to to adjust
adjust
adjust
adjust it it it it through
through the
through
through
installation,
installation, otherwise,
installation,
otherwise,
otherwise, it it it it could
otherwise,
could
could lead
could
Initialize success, type of Normal Airplane selected
Initialize success, type of Flying-wing(Delta-wing) selected
Initialize success, type of V-tail selected
Undefined Model Type, check the setting of jumper J1-2-3
Normal Mode, ready for flight
AVCS Mode, ready for flight
Gyro is disabled, ready for flight
No signal, you must get IN 1-2-3 connected before entering setting mode.
center
center
center the
the
the
the aileron,
aileron,
aileron, elevator
aileron,
elevator
elevator
elevator and
the " " " " Sub-Trim
the
the
Sub-Trim
Sub-Trim
Sub-Trim" " " " function
function
function within
function
lead
lead
lead to to to to losing
losing control
losing
losing
control
control
control or or or or even
even
even
even crash
crash
crash during
crash
Description
Description
Description
Description
support@geeetech.com
and
and
and
within your
within
within
your
your
your
during
during
during
Advertisement
