Table of Contents
Advertisement
PROTECT
The USB device is write-protected.
PUSH STOP
You tried to perform an operation
that can be performed only when
the playback is stopped.
READING
The system is reading information
of the disc or USB device. Some
operations are not available.
REC ERROR
The transfer did not start, stopped
partway, or otherwise could not be
performed.
TRACK FULL
You cannot transfer onto the USB
device because the number of files
has reached its maximum.
Precautions
When carrying the unit
To avoid damaging the disc
mechanism, perform the following
procedure before carrying the unit.
Use the keys on the touch panel of
the unit to perform this operation.
1
Press to turn on the system.
2
Touch FUNCTION repeatedly to
select "CD".
3
Remove the disc.
Touch to open and close the disc
tray.
Wait until "NO DISC" appears on the
display.
4
Unplug the AC power cord (mains
lead).
Notes on discs
Before playing, wipe the disc with a
• •
cleaning cloth from the center outward
to the edge.
Do not clean discs with solvents, such
• •
as benzine, thinner, or commercially
available cleaners or anti-static spray
intended for vinyl LPs.
Do not expose discs to direct sunlight
• •
or heat sources such as hot air ducts,
nor leave them in a car parked in direct
sunlight.
On safety
• •
Completely disconnect the AC power
cord (mains lead) from the wall outlet
(mains) if it is not going to be used
for an extended period of time. When
unplugging the system, always grip the
plug. Never pull the cord itself.
Should any solid object or liquid get
• •
into the system, unplug the system, and
have it checked by qualified personnel
before operating it again.
AC power cord (mains lead) must be
• •
changed only at the qualified service
shop.
On placement
Do not place the system in an inclined
• •
position or in locations that are
extremely hot, cold, dusty, dirty, or
humid or lacking adequate ventilation,
or subject to vibration, direct sunlight or
a bright light.
Be careful when placing the system
• •
on surfaces that have been specially
treated (for example, wax, oil, polish) as
staining or discoloration of the surface
may result.
If the system is brought directly from
• •
a cold to a warm location or is placed
in a very damp room, moisture may
condense on the lens inside the unit,
and cause the system to malfunction.
In this situation, remove the disc, and
leave the system turned on for about an
hour until the moisture evaporates.
63
US
Advertisement
Table of Contents
