Table of Contents
Advertisement
Adjusting the Parking Brake
PR 17 AWD, PF 21 AWD
Check that the parking brake is adjusted
correctly by placing the machine on a slope
with the front and rear axles disengaged.
Apply and lock the parking brake. When the
machine does not stand still, the parking
brake should be adjusted according to the
following.
1.
Remove the left-hand wing cover.
2.
Check that the parking brake is not on.
3.
Adjust the play between the casing and
the adjustment screw to 1 mm (0.040")
when one pulls the casing. This gives
play on the pedal of approximately
40 mm (1.5"). Adjust using the nuts on
the adjustment screw.
4.
Tighten the nuts moderately to avoid
damaging the threads.
5.
Check that the parking brake works.
6.
Assemble the left-hand wing cover.
!
WARNING!
A poorly adjusted parking brake
can result in reduced braking
ability.
Adjusting the parking brake
PR 17, PF 21
Check that the parking brake is adjusted
correctly by placing the machine on a slope
with the front and rear axles disengaged.
Apply and lock the parking brake.
When the machine does not stand still, the
parking brake should be adjusted according
to the following.
1.
Position the machine on flat ground.
2.
Remove the transmission cover.
3.
Unhook the spring (A) from the screw
(B).
4.
Make sure the parking brake is released.
5.
Adjust so there is 1 mm play between the
outer cable and the adjuster screw when
you pull the outer cable.
Adjust the adjuster screw using the nuts.
REPAIR INSTRUCTIONS
Wing cover
Adjusting the parking brake
A
B
45
English-
Advertisement
Table of Contents
