Table of Contents
Advertisement
Quick Links
SnowMax 724/824 QXE Snowthrower
Model No. 38711—Serial No. 316000001 and Up
Model No. 38712—Serial No. 316000001 and Up
Introduction
This machine is intended to be used by residential
homeowners. It is designed for removing snow from
paved surfaces, such as driveways and sidewalks, and
other surfaces for traffic on residential or commercial
properties. It is not designed for removing materials
other than snow, nor is it designed for clearing off gravel
surfaces.
Read this information carefully to learn how to operate and
maintain your machine properly and to avoid injury and
machine damage. You are responsible for operating the
machine properly and safely.
You may contact Toro directly at www.Toro.com for machine
and accessory information, help finding a dealer, or to register
your machine.
Whenever you need service, genuine Toro parts, or additional
information, contact an Authorized Service Dealer or Toro
Customer Service and have the model and serial numbers of
your machine ready.
Figure 1
model and serial numbers on the machine. Write the numbers
in the space provided.
1. Model and serial number location
Model No.
Serial No.
This manual identifies potential hazards and has safety
messages identified by the safety alert symbol
© 2015—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
identifies the location of the
Figure 1
(Figure
Register at www.Toro.com.
which signals a hazard that may cause serious injury or death
if you do not follow the recommended precautions.
1. Safety alert symbol
This manual uses 2 words to highlight information.
Important calls attention to special mechanical information
and Note emphasizes general information worthy of special
attention.
For models with stated power, the net power of the engine was
laboratory rated by the engine manufacturer in accordance
with SAE J1940. As configured to meet safety, emission, and
operating requirements, the actual engine horsepower on this
class of snow thrower will be significantly lower.
2),
Form No. 3396-391 Rev A
Operator's Manual
Figure 2
Original Instructions (EN)
All Rights Reserved *3396-391* A
Printed in the USA
Advertisement
Table of Contents
Related Manuals for Toro 38711
Summary of Contents for Toro 38711
-
Page 1: Introduction
Note emphasizes general information worthy of special machine properly and safely. attention. You may contact Toro directly at www.Toro.com for machine For models with stated power, the net power of the engine was and accessory information, help finding a dealer, or to register laboratory rated by the engine manufacturer in accordance your machine. -
Page 2: Table Of Contents
This machine has a sound pressure level at the operator’s ear Operating Tips ............11 of 89 dBA for model 38711 and 93 dBA for model 38712, After Operation ............11 which includes an Uncertainty Value (K) of 1 dBA. The sound Safety..............11... -
Page 3: Safety And Instructional Decals
Safety and Instructional Decals Note: Safety and instruction decals are located near areas of potential danger. Replace damaged decals. 131–1785 Order part no. 131–5921 1. Auger drive—squeeze the lever to engage; release the lever 4. Thrown object hazard—keep bystanders a safe distance from to disengage. -
Page 4: Setup
Setup Loose Parts Use the chart below to verify that all parts have been shipped. Procedure Description Qty. – No parts required Unfold the handle. Bolt (1/4–20 X 1–1/2 inch) Lock nut (1/4–20 inch) Carriage bolt (1/4–20 x 1 inch) Install the discharge chute. -
Page 5: Installing The Discharge Chute
Installing the Discharge Chute Parts needed for this procedure: Bolt (1/4–20 X 1–1/2 inch) Lock nut (1/4–20 inch) Carriage bolt (1/4–20 x 1 inch) Lock nut (1/4–20 inch) Screw (1/4–20 X 5/8 inch) Procedure 1. Insert the chute post through the bracket into the base of the machine and secure it using a bolt and a lock (Figure Figure 5... -
Page 6: Filling The Engine With Oil
No Parts Required Procedure Your machine comes with oil in the engine. Model Max fill 38711 0.5 L (16.9 oz) 38712 0.7 L (23.7 oz) Oil type: automotive detergent oil with an API service classification of SJ, SL, or higher. -
Page 7: Product Overview
Product Overview Operation Before Operation Safety • Use extension cords and receptacles as specified by the manufacturer for all machines with electric starting motors. • Do not operate the machine without wearing adequate winter garments. Avoid loose fitting clothing that can get caught in moving parts. -
Page 8: Checking The Engine-Oil Level
• than 10% ethanol by volume, such as E15 (contains 15% Exercise extreme caution when operating on slopes. ethanol), E20 (contains 20% ethanol), or E85 (contains • Never operate the machine without good visibility or 85% ethanol). Using unapproved gasoline may cause light. - Page 9 Using the Recoil Starter Using the Electric Starter Figure 11 Figure 12 Note: To use the electric starter, connect a power cord to the electric starter plug-in first and then to a power outlet. Use only a UL-listed, 16-gauge extension cord recommended for outdoor use that is not longer than 15 m (50 feet).
-
Page 10: Engaging The Auger
WARNING The electrical cord can become damaged, causing a shock or fire. Thoroughly inspect the electrical cord before using the machine. If the cord is damaged, do not operate the machine. Replace or repair the damaged cord immediately. Contact an Authorized Service Dealer for assistance. -
Page 11: Clearing A Clogged Discharge Chute
Clearing a Clogged Discharge water heaters, space heaters, or clothes dryers. Allow the engine to cool before storing in any enclosure. Chute • When storing the machine for more than 30 days, refer to Important: Hand contact with the rotating auger inside the Storage section for important details. -
Page 12: Maintenance
Maintain or replace safety and instruction labels, as necessary. • Do not change the governor settings on the engine. • Purchase only genuine Toro replacement parts and accessories. Checking the Engine Oil Level Service Interval: Before each use or daily Figure 16 1. -
Page 13: Checking And Adjusting The Skids
Checking and Adjusting the Inspecting the Throwing Edges Skids Service Interval: Yearly Service Interval: Yearly—Inspect the throwing edges and have an Authorized Service Dealer Check the skids to ensure that the auger does not contact the replace the throwing edges and scraper paved surface. - Page 14 Figure 20 below to select the best oil viscosity for the outdoor temperature range expected: Model Max fill 38711 0.5 L (16.9 oz) 38712 0.7 L (23.7 oz) Oil type: automotive detergent oil with an API service classification of SJ, SL, or higher.
-
Page 15: Replacing The Spark Plug
Replacing the spark plug while the engine is hot can result in burns. Wait until the engine is cool to replace the spark plug. Use a Toro spark plug or equivalent (Champion® RN9YC or NGK BPR6ES). 1. Remove the boot (Figure 22). -
Page 16: Checking The Tire Pressure
Storage Storing the Snowthrower WARNING • Gasoline fumes are highly flammable, explosive, and dangerous if inhaled. If you store the machine in an area with an open flame, the gasoline fumes may ignite and cause an explosion. • Do not store the machine in a house (living area), basement, or any other area where ignition sources may be present, such as hot water and space heaters, clothes dryers, furnaces, and... - Page 17 16. Cover the machine and store it in a clean, dry place out of the reach of children. Allow the engine to cool before storing it in any enclosure.
- Page 18 Notes:...
- Page 19 The Way Toro Uses Information Toro may use your personal information to process warranty claims, to contact you in the event of a product recall and for any other purpose which we tell you about. Toro may share your information with Toro's affiliates, dealers or other business partners in connection with any of these activities. We will not sell your personal information to any other company.
- Page 20 Toro Product listed below if defective in materials or warranty does not cover the following: workmanship or if the Toro GTS (Guaranteed to Start) engine will not start • Cost of regular maintenance service or parts, such as filters, fuel,...